CLAKE TWO & PRO LEVER INSTRUCTIONS & FITTING GUIDE: part 1

[@joti108]

I've have one for 3 months. I love it. I will have one on every bike I ever own. Beautiful engineering.

[@loyal2thesoil57]

I have to say this is the most amazing addition to the motorcycle. You guys better start buying CNC machining centers to keep up with the demand once every manufacturer decides the foot brake is as obsolete as an appendix. Great job guys! It puts a smile on my face every time I pull that brake. If you ever need someone in S.F. California to show and tell your Clake to a curious customer I'd gladly show them my bike.

[@clake729]

Thanks Yuri, demand is picking up quickly and we are installing a second CNC machine to reduce delays!

[@dalerucker67]

sure does make sense how much does it cost US?

[@v4sdude191]

Dale Rucker almost 1k

[@eatshitcommies]

Thanks for the video. After 3years working flawlessly i had to bleed the rear brake slave cylinder and was lost until i watched this quick refresher.

[@JacobSnover]

Just purchased a Clake Two and was wondering if i can reverse bleed the clutch? I installed a magura on my bike first and it didn't want to gravity bleed, so i did a reverse bleed from the slave cylinder and it worked well and fast. Is gravity bleed preferred, or does reverse bleeding not work or damage anything? Im mechanical and will do it however instructed.

[@double-oseven5725]

Much appreciated brother!!

[@FredBGG]

Thanks for making such a good installation video. Made for a nice installation. However I have to admit I did not keep the floor of my garage as clean as you did... blush.....

[@soulomoto]

Hi Guys, I'm hunting for your review of the Clake Pro. In the Clake 2 vid, you mentioned there'd be one. I'm just wondering if it was ever made? Thanks!

[@jonoj7666]

What do you so with the old clutch electrical switch?

[@madman432000]

Can you make a 2 finger clutch lever instead of just a single finger? Why does the brake line need to go from the rear MC up to the Clake and then back to the caliper, if retaining the rear brake foot pedal. Seems like one line from the Clake brake MC to the rear MC and stack the banjo fittings would get the same result? Maybe?

[@2wheeltango]

The hand leaver needs to be independently operated from the foot lever.... the master cyclenders act as valves, if you link the hand leaver directly to foot leaver, you could not actuate the hand leaver with out working the foot leaver at the same time.....

[@matthewmattholew7905]

I have tried your technique here 12 times. Including repriming the slave cylinder with the oem clutch master cylinder several times to eliminate air in the line and slave cylinder. It will not build any pressure. It also will not allow fluid to rise to the top of the bleed port under gravity like you show. I am getting very aggravated with it. Can you give me any ideas why it will not bleed properly? I find this system to be the hardest to set up and bleed of any system I have ever dealt with. Certainly I am missing something here or something is broken.

[@vasillir]

@5:09 i can't seem to get to this step. I press the hole and slowly pull out, wait 30 seconds or so, if i pull in again fluid starts coming out. So i repeat, and then pull all the way out, but no fluid comes out. Any suggestions?

[@adamleehowarth]

Is there a system for a harley, i got a 2008 crossbones,with a frankenstien trike rear.

[@uap4544]

I even like the music

[@Foredore]

MAKE ONE FOR CABLE CLUTCHES!!!!

[@jlkoelker]

you can get hydraulic cable puller that mounts like a cable clutch

[@hughjorgan9328]

If you understand the difference between cable and hydraulic you'd know why that won't work.