Closely coupled tees

[@Skeletoncrew46and2]

Been and going on more courses about this. Your video has made it easier to understand than some of these course's.

[@sodig876]

Great video that's made it much easier to understand 👌

[@alfypierri8022]

Very well explained. Thanks you

[@valentinbelchev3301]

Great video and explanation. Thanks 👍

[@jockster5525]

Thanks for your efforts 👍...

[@TDOWLP]

Thank you. very good explanation.

[@aliatas6647]

In your experience, is one CCT enough to feed UFH & rads? or would you recommend two CCTs, one for each zone? Thanks for the video 😁

[@craigwebster7405]

Nicely explained 👍

[@hufartd]

Instead of a non return valve on the radiator return (which I feel are very restrictive) I used a zone valve instead wired in parallel with the radiator pump to stop back flow while underfloor only was running. Do you see any issues with this?

[@randomcamerajunk6977]

Will you not have interplay between the 2 pumps on the one CCT? Just add a second pair of ccts for the UFH after the higher temperature rad ccts 🤔

[@CommercialGasEngineerVideos]

You're back. I didn't realise. Lovely jubbly.

[@henrybartlett1986]

Kimbo’s course is life changing.

[@stewartharrod1706]

Amazing video

[@simonkay2273]

Great video as always think I need to get on some of these courses.

[@thementalgasman3tgasmainte317]

Great courses to go but they’re not easy

[@craigwebster7405]

Nothing worthwhile is

[@grantbrown6089]

If I was going to add a h/w circuit to this would that need its own pump too thanks and great video👍🏻

[@paulreece7148]

Hi, I’ve piped up a couple of systems after watching this. One question o have is, if the ufh manifold was say 15 metres away would you for an extra pump on that circuit to help with the flow?

[@thementalgasman3tgasmainte317]

No you shouldn’t need the xtra pump it will work with out , unless it’s 15m of elbows and restrictions then you would need to give consideration to reducing that resistance

[@magicno001]

I guess your manifold in that plan is drawing its own water as in not an injector manifold?

[@leepickett3655]

Really good this mate 👍

[@mikecave4154]

Could the normal method off boiler pump Doing upstairs rads and downstairs underfloor heating to the manifold on a normal s plan without close coupled tees there a lot out there without them

[@SisterAbdullahX]

They are all high flow temp

[@jasonwhittle5008]

Did you wire the external pumps to the orange / switch live in wiring centre mate 👍

[@thementalgasman3tgasmainte317]

On this occasion I wired the pump to the brown on the zone valve as the switch live back from the UFH would energise the radiator pump when there is no demand

[@ginola602]

Great video !

[@d.costacostagliola7298]

Top video mate

[@joncoke8208]

GreT video Mate how Much r these courses roughly? Also recommend any breakdown courses you recommend?

[@joncoke8208]

Also Are close Coupled Tees instead of Llh

[@tethadam6678]

Great video