How did you hold the clutch in place while tightening the pressure plate? The hole is too small to pull the tool back through. My pressure plate looks like yours so how did you get it back out or how did you hold it in place? I’m about to change my clutch with a 335is clutch. Did you take that center piece out of it? And if so does it need to be reinstalled?
@crtmotorsports7423 Жыл бұрын
Impact on and then had a pin mad to lock fly wheel while i torque it
@emdot3172 жыл бұрын
I'm about to do the same clutch with a SMFW. When you installed the new throw out bearing, do you remember if it was in the low or high position for the iS clutch?
@crtmotorsports74232 жыл бұрын
Sweet!! I was soo bummed that I couldn’t get smfw cause of backorder man. And i think its more on the low side since i have the stock flywheel
@emdot3172 жыл бұрын
@@crtmotorsports7423 thanks man!
@julian327852 жыл бұрын
Did you have to change the flywheel? Or just the clutch
@crtmotorsports74232 жыл бұрын
It was actually in really good condition so i didnt bother and mainly because smfw wad out of stock. I just sanded it down a bit by hand incase it was glazed anywhere
@757BBB2 жыл бұрын
How long did it take you to replace it?
@crtmotorsports74232 жыл бұрын
First time took 2 full days on the floor now on the floor takes about 4 hours 🤣🤣🤣