CNC Plasma : Floating Head (Z)

[@kartikswami1232]

Sir , plz tell me How to configure the floating head micro switch in the mach 3 to sense the initial height ??? Plz reply. ..

[@nicholas0185]

you forgot to say you need to change the refhome to false for g31 probe

[@ช่างเก่งบรบือ]

What port do you connect the limit switch to?

[@jericojp2012]

quisiera construir un cabezal flotante en casa, puedes compartir los planos @Mitch?

[@luiseduardoramirez5164]

This post works only in mm, my machine Is in inch, i can use this post?

[@ltgengr]

My question is you operate a 4x8 CNC Plasma in a one-car garage?

[@juliangmeiner1913]

Hallo! Super Video! Ich möchte das bei mir in Mach 4 implementieren, woher weiß die Steuerung auf welchem Pin dein Schalter im Floting Z ist?

[@javiergordopeula8240]

Hi mitch i am trying to set a floating head in my plasma but i use LazyCam for creating GCode. Do you know if it possible to configure the Z Offset in that program, or it is only possible in SheetCam. Good Job and Vielen danke

[@MitchGreeley]

Hi Javier, I have never used LazyCam so I can't say. Thanks for the comment and good luck on your search!

[@javiergordopeula8240]

@@MitchGreeley thanks mitch. I finally desisted and i followed your steps. Anyway, sheetcam is much better software than the Lazy one. Thanks for your tips

[@yassinewakine9386]

THINK YOU IS NICE VIDEO

[@yassinewakine9386]

HI I USE ARDUINO FOR MY CNC PLASMA AND I WANT MAKE floating head can you help me

[@yassinewakine9386]

program i use is universal gcode sender

[@rajarshimanu2856]

Which thc did you used

[@MitchGreeley]

Proma

[@kenkitching457]

How do I wire the switch

[@MitchGreeley]

It's a NC (normally closed) switch on the mounting plate. This runs to the controller and signals Mach 3 during the probing sequence in the Gcode. @ min 2:27 I show the switch engagement.

[@kartikswami1232]

Sir , plz tell me How to configure the floating head micro switch in the mach 3 to sense the initial height ??? Plz reply. ..

[@nilsnowinski6745]

Hello, great video. Can you send me the whole script from the postprocessor. Find that very interesting and would like to try that with me. I would the gladly the email address of me then by PN communicate. Thank you and greetings from Germany

[@MitchGreeley]

Hallo Nils, ja sicher kein Problem!

[@nilsnowinski6745]

@@MitchGreeley Das klingt super. Die E-Mail Adresse ist [e-mail] Hast du den NC Schalter von dem Schwimmenden Brennerkopf als Z Home in Mach 3 konfiguriert oder als Probe? Danke für deine Hilfe 😉

[@kartikswami1232]

@@nilsnowinski6745 Sir , plz tell me How to configure the floating head micro switch in the mach 3 to sense the initial height ??? Plz reply. ..