cnc thread rework

[@16zips-HTX]

Holy crap man. You did that super quick... what was your jaw pressure? And those welded soft jaws too.... No springing? With the T-nuts little high out of the Chuck. All that screams jaw springing foward misalignment on the Z some.. not a huge fan of jaws like that. Only if I can bore them in the closed position chucking on a bore ring? What type of insert/and tool? Looked like a ID grooving tool.. cool stuff man

[@RaviKumar-oo1rs]

You are one in a legend for CNC🎉

[@un-factory]

Thank you 😊

[@AlbartAlbart-jf3rv]

Super Bro

[@un-factory]

Your technology and knowhow very well 👌

[@sathyarajsathya2265]

Thank you very much for your support as always

[@muthurajp9390]

I want cnc taping attachment which price

[@sathyarajsathya2265]

Tapping attachment neengale ready pannalam bro

[@muthurajp9390]

eppadi bro ethavathu drawing irrukka parts oda photo irruntha mail anupa mudiyama bro

[@sendhilkumarc7781]

Supper

[@maharanjith2455]

It is simple method, RPM change panni epti root setting panni rework pannurathu sir..

[@SanjuKavitha-ne8sy]

Super

[@pandiselvam6141]

Piece veliya kalattida rework panna mudiyatha

[@sathyarajsathya2265]

Rework pannalam ana z offset change panna koodathu

[@RajatKumar-hl1or]

This is the grooving tool you are using

[@sathyarajsathya2265]

Yes

[@RajatKumar-hl1or]

Are you making square thread

[@sathyarajsathya2265]

Yes

[@suniltanwar8458]

Plz make a optithread by manual or macro programe

[@sathyarajsathya2265]

I will try bro

[@suniltanwar8458]

@@sathyarajsathya2265 we will wait plz make soon

[@AjayJi035]

Jaw और वर्क पीस को मार्क करना चाहिए था बस

[@sathyarajsathya2265]

Mark any part of the spindle without removing the threaded part with its starting point straight against the tool.

[@SathyaS-io6bk]

Good thinking

[@HanuShree-s8m]

Super