Computation errors - FLAGS - Trimble Business Center

[@GlynHunt-le9ir]

Hi. I’ve got an unusual question. I’ve done all my processing, cleaned up my baselines and deleted out the unnecessary ones. However now I find I want one particular baseline back. How can I do that with TBC without loosing all of my other baseline edits please?

[@ProSiteConsulting]

hi can you email me a sketch what you looking for I am not sure I completely understand the question !

[@Aj-hx5ct]

Are you able to do a vid on the utility module and making trenching surfaces from this? Thanks for doing these vids, has been really handy while I’m learning TBC keep up the good work 👍🏿

[@ProSiteConsulting]

HI AJ, thx for support, yes it is definitely on the list !

[@taekwonwelchify]

I'm getting an out of tolerance flag because the rod was tilted a bit on a shot (but its ok its not that critical for this survey). I need that point to perform a site calibration but tbc wont let me use that point because of the flag and its saying to fix the point (??) so that it can be used in the calibration. but I cannot find how to fix it or even just turn the flags off so that I can use the point in the calibration... any ideas?

[@ProSiteConsulting]

Hi Erick would you be able to send me the VCE archive so I can take a look ?