Configuring Multiple PTZ 9000's to one DVR 123CCTV

[@storminstormin7328]

Just to say you have saved me and no doubt thousands of other noddies like me a lot of time and gave us top class info... Much appreciated and I thank you for taking your time to help me ... Regards Stormin Stormin

[@Desireez1023]

Awesome explanation, I have a question though, how can I install a joystick with this setup? or is that even possible?

[@frosty-ke1xe]

please can you help with the wiring of 360 Visions Predator CCTV System? I have wired it through the Matrix Control Unit16/2 -and the joystick VKXM-0845-EU controller with RS485 cables, all that is coming out of the camera is a bunch of wires that have been chopped off. I have managed to identify all of them, but am unsure as how to wire the 4 wire twisted pairs, i.e., Red & Orange TX/ and Purple & Blue RX From the camera do they go to the matrix or the controller, and which pins on a RJ11 6 wire plug? any help would be very much appreciated as 360 vision diagrams only cater for the special power supply connector board, there seems to be no circuit diagrams available, I can supply pictures...

[@sirajchanna]

Plz mention here which port u have use for ptz controller in dvr and plz provide dvr manual and dvr model number of this vanguard dvr

[@aaroncenteno6691]

Do you need multiple rs48 for multiple pts cameras?

[@frosty1243]

can someone upload a video of how to set up a early wired 360 vision predator cctv camera using rs485 thank you

[@salemelkholy9639]

are i can connect joysteck dahua NKB1000 with NVR Panasonic WJ-nd400

[@shanthekumara4761]

Can i apply 95 for any camara

[@MrYayoperez]

Very good explanation. I was so confused when I first installed 2 ptz cameras. Now I can go back to the site and try to use the knowledge that I learned from you. I am using Q-See cameras. On channel 1 and 16 I have the same models (qd6531z-K). They both came with Channel 1, Protocal D, Address 1. So I need to change Channel 16. Do I change the address to 16 on that camera, or just put any other number except 1? Thanks

[@123cctv]

Have no idea about Q-see equipment. Try giving their support team a call.

[@reginaldo3911]

the better explanation.

[@romanandsahu8535]

good