Connected to hikvision NVR New software(Build 2207XX or above) cannot display image solution

Anpviz Uprime Series POE Cameras connected to hikvision NVR New software (Build 2207XX or above) cannot display image solution
1、Modify the camera's corresponding POE channel connection mode to manual, the protocol to onvif, and then click OK to connect normally, as shown in the figure.
2、Upgrade the camera software version, please provide the current camera version information and send an email to the [e-mail], it will be solved in time.

[@mm56786]

My 4 tapo ip wifi cameras are in hikvision 4:channel NVR shows problem unreachable net work and plz edit parametre plz advise and rrply

[@SaraSherin-yo7wc]

One of my cameras isn’t showing any video feed, and the message says to "change the parameters." How can I fix this?

[@이성민-g3k]

Is there any way to plug and play like before with hikvision new firmware? I want to use motion detection like before but not with onvif

[@anpvizsecurity]

Using the onvif method to connect can also use the motion detection function. Update the firmware version of the Uprime camera can plug and play, and this problem has been solved long ago. Please send your camera version to [e-mail] to get the latest firmware.

[@srishant6781]

Didn't work

[@anasvAnas-wf5zq]

Didn’t work

[@anpvizsecurity]

Click the connection status to view the cause of the error prompt and troubleshoot accordingly. If you still have problems, you can contact [e-mail] for support.

[@anpvizsecurity]

If you still have problems, you can contact [e-mail] for support.