Connecting VControl to GooSky S2 FBL

[@CaptainCrash999]

Thanks for this video Adam, used it yesterday to setup my OMP M2 using the new Mikado 7ch receiver, absolutely spot on and after setup flew amazing! Many Thanks, Chris

[@ThisIsSampson]

I'm curious why you kept the Goosky S2 FBL and added the VBar NEO with it. I thought the VBar was supposed to completely replace the Goosky FBL system.

[@martinsandford4204]

You should add that this works with tge omp helis using the same setup ;)

[@rdjvelasquez]

Thank you for your video, and how easy to follow this was. Question, do you by any chance know how to enable the safety switch while using the Goosky S2?

[@BBQ_FIRE_MORE]

Hey, thanks for the Video, Do you have a pic from the Wireing?

[@nfavor]

Excellent explanation!

[@Kilian_B_H]

Awesome Video, this helped me a lot, thank you :) Could you maybe also do a video in which you show how to set up the Stability Mode as rescue on a Switch ?

[@ademaine1]

I think this should help: kzbin.info/www/bejne/gl6TmqB9nJqlm68

[@gorix5]

I've tried above solution with Vbar RX-only 7 channel receiver (MIK05560) and it doesn't work. When I've connected Goosky S2 FBL SBUS port to AUX1 on Vbar nothing happened, RX hasn't powered on. However after connecting to CH1 or CH2 port not AUX1 Vbar powered on. Connecting to Vbar EVO AUX1 port also works fine. Maybe my unit is faulty or it's impossible to power Vbar RX-only through AUX1 port. Update: Issue was resolved by using different polarity than when connecting to CH1 or CH2 port - plug has to be rotated 180 degrees for AUX1. I haven't tried that before because I was afraid to fry the board.

[@ThisIsSampson]

Did you ever figure this out?

[@dragbdahdr3903]

can you set up a goosky s2 with a classic v-control?

[@G40Racer7885]

Hy is it possible to download the Makros and lload in the touch??

[@williamtam6732]

Did you use one of the channels for stability mode? Mainly as a rescu.

[@ademaine1]

No I didn't set up a channel for this. I`ll add a video later in the week showing how to do this if there is interest in this, I didn't require this feature and it defaults 'off' if you do not set a channel.

[@G40Racer7885]

Where i can Look what Chanel is for Stabilität ... i want to Tage it for rescue..on the vbar

[@ademaine1]

I think this should help: kzbin.info/www/bejne/gl6TmqB9nJqlm68