Control a Servo using a Potentiometer using Arduino Mapping

[@ConnieGuillero]

can i have the code

[@darinmoodley6237]

wheres the code????

[@mrrobotech9969]

How much cost of internet in your country as 1GB cost?

[@mrrobotech9969]

Keep making videos , love u from India ❣️❣️❣️

[@joryaock]

I’ve never used an arduino. Where can I get this interactive software?

[@danoweb]

coming from Raspberry Pi and learning Arduino this helped A LOT! Thank you for these videos, keep being awesome!

[@JUDEPOPPGamingb23ra]

Hi I assume that if you program the servo at -180 it will go in the opposite direction? The reason I am asking this is because I have built a robot arm but 3 of the axis are going backwards and I think iys meant to be programmed at -180

[@LearnRobotics]

You'd have to look at the Servo library. I think it's positional. i.e. If you're sitting a position 180, to move back to zero, you'd program 0. Double check the docs.

[@ariel18012]

Muy bueno tus vídeos, podrás agregarle los subtitulos en español.....sigue así...!!!

[@muhammadnazrulaimanbinmohd5104]

Hi, is it possible to set or manipulate the servo speed when controlling it with a potentiometer?

[@LearnRobotics]

yes by playing around with timing and conversions

[@omsatpathy5455]

It was good.Would have been better if youd have gone a little slow

[@LearnRobotics]

Thanks for the feedback!

[@hi-tk4hu]

amzing video! thank you

[@krishnawa_]

I love this channel really awesome tutorials🙂

[@ryanpaye454]

How would this look like on HCS12?

[@LearnRobotics]

Probably similar to programming a Servo by setting the duty cycle. I have an example that shows the Calculations with Raspberry Pi, concepts should be similar if you read your datasheet - check it out here: www.learnrobotics.org/blog/raspberry-pi-servo-motor/

[@satellite1975128]

THANK YOU FOR THIS!!!!!!!

[@DSCVVIKASVERMA]

Mam which software do you use for making the circuit in this video

[@krishnawa_]

Thinkercad online simulator 🙂

[@DSCVVIKASVERMA]

@@krishnawa_ thanks

[@paulaklockner182]

nice!