Adding copper shielding to the Squier VM Jazzmaster. Skip to the 55:00 minute mark to see the end result
Пікірлер: 5
@nowgearthis11 күн бұрын
End result is at 55:00 mark
@balintkiss2273Күн бұрын
I don't quite get it, you already had conductive paint on, if you had noise issues then add tape to the back of pickguard coz I know they don't do that on squiers.
@nowgearthisКүн бұрын
I had two rolls of the shielding and installed new pickups so I figured I would just go for excessive blockage. 😜
@balintkiss2273Күн бұрын
@@nowgearthis Also did you check electrical continuity between separate foils ? I missed that part or it was not recorded.
@nowgearthisКүн бұрын
@@balintkiss2273 yes, and I have continuity to the pick guard when it is on as well. I have some overhanging shielding out to one of the screws to ensure the shielded guard is in contact. Only way in or out is past the pickups. Bridge and trem are grounded as well.