Very confused. Numerous vids mention the screws dont go in the valley, they go on the ridges. In the valley will allow water to leak through if/when the washer on the screw fails.
@serenap.10412 жыл бұрын
Depends on the pitch and weather conditions in your area. If you have a low pitch and wet weather it should be on the ridge, if you have a high pitch valleys can be used. Always no matter what place screws on ridge of overlaps.
@Mark_Jacobson812 жыл бұрын
@@serenap.1041 Thanks for clearing that up. I'm totally new to building materials and techniques and I was sure they all went onto ridges.
@pedrocondori24512 ай бұрын
Whar about vent on the ridge air
@ITWorksSoftware Жыл бұрын
Maybe I missed it, but you didn't show how to install the side flashing along the gables.
@joeymell78953 жыл бұрын
Your not supposed to screw the panel in the valley.
@Hang10boards2 жыл бұрын
BINGO!!! CRAZY isn't it?😳😳😳
@serenap.10412 жыл бұрын
Yes you can... I don't know where you got your information. This video is from a very well known Metal roofing supplier. Screw placement depends on the pitch and weather conditions in your area. If a low pitch and wet weather ( ridges are suggested) if a high pitch ( valley can be used ) always no matter what always place screws on ridge of overlaps.
@ushouldntjudgeme3683 Жыл бұрын
I do not know the thickness of this metal but I went to Lowe's and used a micrometer to check thickness, it was 0.015" pretty dang flimsy, that ridge is easily going to flatten out as the washer is compressed. So I'm at a loss of what to do now. I came to the video for answers and I need to finish up my wife's shed project soon, very soon.
@MrGwizyadig Жыл бұрын
@@ushouldntjudgeme3683 how did you handle it?
@ushouldntjudgeme3683 Жыл бұрын
@@MrGwizyadig I went to Carter Lumber and they offered 26 gauge metal, thicker but not by much, project is on hold this week.
@blurglide9 ай бұрын
How big should the pourlins be?
@tomk83123 жыл бұрын
i like the idea of a metal roof, but i've always thought exposed fasteners were a bad idea. any reason you can't cut the sheets in strips and install them like shingles?
@serenap.10412 жыл бұрын
It could be done but would look like crap... and not to mention a lot of unnecessary work.
@dfk704 жыл бұрын
is it me or is there no overhang like the voice-over suggests there should be when using an eave flashing?
@wolfy14 жыл бұрын
What size stitch screws?
@MetalMachineryTechnology Жыл бұрын
super machineries
@georgearcega7302 Жыл бұрын
Not complete instruction
@sallyannburns92483 ай бұрын
Do all Americans need to listen, to someone's life history that goes on and on . to buy some potion to help them loose weight . Do they ever get to the point. It's like listening to an audio book
@zacksaylor8203Ай бұрын
This is very incorrect
@rainrosebravogaming41312 жыл бұрын
very wrong plss dont do this you will ruin your roof. 🤣