Vintage Thursday. Ferguson tractor front axle removal.

[@johnlydon533]

Great video Dan. Lot of work to be done on the grey Fergie. Looking forward to next video on it. Enjoyed watching. 👍🏼👍🏼

[@andrewpriestley9611]

Good to have you back Dan, was getting worried. 😂. The bloody awful music is back too but I love these Vintage Thursday videos. 👍

[@charleshart6992]

Another great Vintage Thursday video Dan!

[@MrBen-uk]

Happy days can’t wait for more 👍

[@bedfordpump]

Really looking forward to the future videos of this project. Lots to learn from your videos, thanks Dan.

[@paulthompson8467]

Good video Dan nice Ferguson we had the same problem with the front cradle on our MF 135but an engineer friend of ours bored out the housing and pressed in a new bush

[@dougpeterson5257]

Great to see you and the new video, I'm very anxious to see the next one.😊

[@jhill5221]

Top job as always Dan👍🏻🛠️

[@wulliewhyte544]

The grey fergie is going to keep you busy this winter😂

[@pauljones2633]

Looking forward to this mini series. Everyday is a school day!!

[@douggilroy1188]

Thanks Dan, nice to see.

[@timhenning18]

Keep em coming Dan 👍👌

[@whathasxgottodowithit3919.]

Thank you for posting, on the TEF we had on a brass plague under the KI-Gas pump it gave full instructions for cold starting, and using the Handle and the decompression feature to assist starting in the cold., however we could never turn it on decompression, let alone fast enough to start it. They put the front decompression lever where you could reach whilst cranking, they must have been fit guys back in the day if anyone ever did start it with the handle.

[@keiththomas2253]

I can also remember trying to start the Fergy on the handle using the decompressor lever, but it would just stop dead when you put it back on compression, so I was never successful. I can’t remember reading the starting instructions, but it was over 60 years ago!

[@graemebowyer4901]

Looking forward to the upcoming videos

[@MasseyDave]

👋 nice to see u back , that Nora wellies u have on there ? 👍 good vid 👍 cheers Massey Dave

[@AlextheDutchDairyfarmer]

👍👍

[@dazsden]

You need to get the jack under it. Wear in the front axle pin etc. will cause that!

[@MrBen-uk]

Bevel weld and lathe maybe

[@calumanderson5617]

Thank you for the video Dan enjoyed as always, 🙂👍question, do you think you've managed to persuade Farmer p to buy the 3080 ???? 🤔 It's sooooo ideal...😊

[@CowfarmerDan]

Not yet

[@casto-]

Glad I don’t have a starting handle, it would probably hit the top of the radiator 😆🫣

[@julianhawker7672]

Bore and sleeve the casting ? or are new ones available and cheap............

[@CowfarmerDan]

Not available as far as I know. It's a steel fabrication rather than a casting.

[@julianhawker7672]

@@CowfarmerDan Weld up and bore job then ?

[@CowfarmerDan]

@@julianhawker7672 yes