Creating a Parametric Diagrid pattern on any surface using Data Structures in Rhino and Grasshopper

[@VictorGonzalez-vj6jy]

You lost me at 10:50. There’s a jump. When did you add shift list? And what does that affect? When I added it it connected 0,0,7 3 with 0,0,6 0 and 0,0,8 0

[@DARCHitecture]

Hi, we started our membership program to access exclusive content, not on KZbin and you will get certified too. Check it out we have 70% discounts only for a few more days. www.acedesigninstitute.com/membership#nav_bar

[@Runesu117]

I can't seem to connect all the lines at the same time to the pipe function

[@boyonglu5257]

hold shift during connection

[@DARCHitecture]

Hi, we started our membership program to access exclusive content, not on KZbin and you will get certified too. Check it out we have 70% discounts only for a few more days. www.acedesigninstitute.com/membership#nav_bar

[@DARCHitecture]

Hi, we started our membership program to access exclusive content, not on KZbin and you will get certified too. Check it out we have 70% discounts only for a few more days. www.acedesigninstitute.com/membership#nav_bar

[@VictorGonzalez-vj6jy]

THANK! You!

[@DARCHitecture]

Hi, we started our membership program to access exclusive content, not on KZbin and you will get certified too. Check it out we have 70% discounts only for a few more days. www.acedesigninstitute.com/membership#nav_bar

[@durkeejw]

I had the same issue as Shuai Liu below - the Shift List part of the tutorial is skipped over/editted out

[@DARCHitecture]

Hi, we started our membership program to access exclusive content, not on KZbin and you will get certified too. Check it out we have 70% discounts only for a few more days. www.acedesigninstitute.com/membership#nav_bar