Creating Mass Haul Diagram and Sections

[@mattiaseriksson3679]

Great video! I especially like that you show problems one might run into and how to fix them. Maybe you can solve the issue with the triangles showing up again by using a region at the bridge area and delete the surface in the corridor properties while you work on the cut and fill. Just a thought. :)

[@franciscodalosto2414]

Great video. I will use this knowledge in my class. ty

[@MohammadUmar-py3du]

Hey, I want to thank you for your videos they helped me a lot. But I have been facing some issues in cut fill. Where you described the formation or vertical alignment you managed equally cut fill with grades. I did the same my net worth is 2900 cu.m. Now I have done all the things in my corridor when I got the volume report I found my cut fill net is 10000 How? Can you explain me? Thank you.

[@KyleEvansCivil]

Are you asking how to more even it out? If so then you need to adjust your profile grades and PVI's manually down a little bit at a time. Select one of your PVI's and adjust it downward with the grips around 10cm at a time.

[@MohammadUmar-py3du]

@@KyleEvansCivil No Sir, my concern is i adjusted my vertical alignment and also balance the Cut Fill, it was 2900 cu.m. When i downloaded the Volume Report from the Software The Cut Fill Data was Different. Now it is 10000 cu.m How is this possible when I checked with Surface Volume Report. It was 2900 now it's 10000.

[@KyleEvansCivil]

@@MohammadUmar-py3du Oh, that Volume Report. I am fairly certain that those volume reports read off of the "exaggerated" surface contours. Turn your exaggeration off and see if that fixes it.

[@MohammadUmar-py3du]

@@KyleEvansCivil How can i off the exaggerated Surface at this moment please tell me sir.

[@KyleEvansCivil]

@@MohammadUmar-py3du It is in your surface style, under pretty much every tab.

[@joelpiero5265]

does anyone have the data? i want to practice making mass haul diagram. Anyway, Thanks for the tutorial :)

[@KyleEvansCivil]

The original Data is 4-5 videos back in Creating Points and Surfaces.

[@George-pl7dw]

Did a good job ! But ... you talk in meters from space , not feet from earth

[@KyleEvansCivil]

99% of the world uses Metric... The US military uses Metric... the rest of you need to get on the same page! :)