Creo Part Modeling Tutorial for Beginners | Creo Practice Exercises - 4

Creo Part Modeling Tutorial for Beginners | Creo Practice Exercises - 4. This tutorial shows how to do part modeling in Creo step by step. Solution to practice exercises is shown for Creo software. Creo commands used in this tutorial are center rectangle, extrude, remove material, triangle using line command, mirror feature, take references
#CADCAMTutorials #CADCAMCreo #CADCAM3D
#CreoTutorial #CADTutorials
#CreoParametric #creo

[@oni7441]

Thanks for the lesson, very helpful. But the last piece that you did, was done a bit wrong. You sketched it on the center of the right plane. but in the diagram it is offset by 19 or 16. To accomplish this I create a datum plane offset by the right plane.

[@ahteshamulhaq3381]

Plz upload how to draw geometric dimensions and tolerance (GD&T) in creo

[@anandkhetpal2145]

op max ultra pro

[@michealscofield2498]

Can i start second with horizontal plate???

[@tahiralyousaf]

sir you can just modling or nc in creo pleae if you have nc work on creo so please share i

[@chinmoydas8777]

Software name?

[@adarsh2004]

Pro Engineer

[@ajaykumarvattikala5963]

Pls highlight your link belongs creo tutorials.

[@Atharv_Nigam]

Op

[@ybl456]

Msbte is referring Your Practical In their Learning Manual ..