Creo Tutorial#9 | Design and motion analysis | Belt and Pulley mechanism.

[@himanshunegi1702]

Well done bro. I like it

[@aravindhanr6548]

very good video make more, it is very useful

[@madhavkale5868]

Excellent video.. I suggest including a sketch in the beginning showing pulley dimensions and other parameters. I would appreciate if you could create a video of a engine block-pistons and cam.

[@habibali9752]

hi my sweep feature is giving regeneration failure on 16:08 . im using creo 5 and following all the provided steps u mentioned. the only difference is the diameter for both the pulleys are same in my case.

[@numanahmad3480]

Nice vedio make more vedios

[@abhyankajivane1898]

Perfect explanations I was looking for from long time Thanks alot sir👍👍👍

[@adityabhat295]

Very helpful video ..Thanks

[@borlakuntarajesh6714]

Goooooooood

[@rawammazhar4635]

hello! did you also performed sentivity and optimisation analysis on it?

[@laurinfellner5447]

nice video

[@luisgerardocar9]

Thank you, you helped me a lot. Best regards!

[@giovannimaineri4318]

Nice tutorial, thanks.

[@SolidworksTutorialsVK]

Thanks Jo. M

[@dineshchowdarygadde4294]

Great video thank you for all and you efforts won't get spoil

[@keyurajudiya3271]

You are the best. Please upload more videos of mechanism

[@dragon-gi3gi]

Helped me a lot! I was stuck at the part where I kept adding constraints which made part completely constrained. I missed the instruction where I had to change "User defined" to "Pin" in the dialog "Component Placement".

[@apurvbhagare4679]

Does that belt also rotates in actual?

[@justkk1654]

Please make a video chain and sprocket mechanism

[@Leo-mycos]

I can't choose the surfaces for some reason when adding the belt

[@nicklesmarisusai4571]

I am facing an issue with my file . Can you help please?

[@shivampatel-gd6iw]

bro i want to learn fluid analysis or wind turbine analysis can you help me out

[@habibali9752]

i have worked on a project on vertical axis wind turbine. how can i help u with?

[@shivampatel-gd6iw]

@@habibali9752 need complete tutorial on mechanism and analysis

[@siddhantsambyal5323]

Well this video is quiet good.🖖🖖 But can you please tell me how to make a quarter turn belt drive in creo?

[@naqashabbasi6345]

Only datum plane movings please help

[@dineshchowdarygadde4294]

How to make it run again

[@SolidworksTutorialsVK]

You have to just click on Run Analysis again.

[@dineshchowdarygadde4294]

@@SolidworksTutorialsVK i tried and only one pully is rotating

[@moonrai7054]

Janb ye end waly chez samjh ni arhe nein try ki hai