Very good video as always. Have you ever had to deal with gaps between the layers? I had that problem many times with the slicing method, to the point that I started layering on top of each material when possible. Can the pulling be the cause of it because it actually moves the material?
@alisongallagher3590 Жыл бұрын
I think sometimes it you have too high a heat, or press for too long, the vinyl can actually shrink slightly. The only way I have managed to get round this in some instances, is for the outline, use the new offset feature in design space, but 'inset' by a very small amount, just to make the outline slightly thicker. Hope that makes sense. Additionally, for each layer, I don't press for the full time, only long enough for it to transfer. I give it the full time once all the layers are in place and carrier sheet removed
@minawhite Жыл бұрын
@@alisongallagher3590 I'll try the offset solution, and also my pressure. Although I press for less time when I layer, the truth is I do press it quite a bit, so shrinking is possible! Thank you so much for your answer 😊
@CriftyCrafty Жыл бұрын
It can happen a lot with multiple layers because the layers can shrink. I’m filming a video this week in it but as said above I reduce the press time. I normally do it for over 4/5 layers