CUSTOM BARWORK! Ranger Raptor V2 Build (Part 5)

[@skbid1]

Really like this but there's some tweaks I'd like to see.the main bar is a bit wide on both sides, if you look from the front it cut be cut a little to contour with the fenders better. The side openings would look better with plate rather than open. Maybe a couple other small things here and there but overall I like what you've done. Again these changes are my opinion and in no way detract from the work you've done. If I were to commission you we could definitely start here and make some minor tweaks to get where I'd like to see it.

[@Webzz-jz1km]

my dream is to have a tough 4x4 and a sleek r33 gtst this is just great love the vids

[@LachieKing]

Thank you so much! With hard work and a dream my friend, anything is possible!

[@wolfee1920]

🔥🔥🔥🔥🔥

[@LachieKing]

Thanks mate!

[@wizzylizzy69]

That’s some solid work. As someone who was going to keep my raptor stock this makes it hard yahahaha

[@LachieKing]

He did a really good job! I was super happy with it

[@wizzylizzy69]

@@LachieKing have you weighed the car with all the mods? I’m assuming you did springs too?

[@LachieKing]

@@wizzylizzy69 nah, you don’t play with raptor shocks. Theyre tuned very well from factory. I haven’t really added much weight; I removed a lot of factory bits and replaced them with the same materials. The guards and whole front fascia are ABS plastic, only the bonnet is steel and the bar isn’t any heavier than the original factory bumper with the steel reo inside it

[@wizzylizzy69]

@@LachieKing good to know. Yeah I don’t want to play with mine either