CX5 2018 KF2P Replace Rear Hub Unit /Bearing . You can check the sound.subtitled.

[@mitchelltheriot4504]

Thank you for the detailed and informative video! I feel better about doing it myself now.

[@HackerCSVideos]

I finished the job. Your video helped a lot. Thanks for making it!

[@BALIHAIPROPERTY]

hello suyuki iam indra from bali i have mazda cx 7 mybe you can help me share what oil transmission can use and suitable for this car thnks

[@HackerCSVideos]

Great video! What do you use to remove the bolts at the back? I tried a long extension with my impact wrench, but there are too many things in the way. I need something that can rotate and also withstand high torque. Do you have an suggestions?

[@4614]

Thanks for watching! I used the following to remove it. · 3/8 Breaker Bar. Length is 10" (25cm). · 14mm normal socket and deep socket. · 3/8 universal ball joint. I used the Breaker Bar first when loosening the bolts. Then I used a ratchet or impact wrench. I couldn't use an impact wrench in some places.

[@autograph415]

Is it essentially the same as the front bearings? I've got a 2013 xz5 and beleive 1 of them went out just gotta figure out which 1

[@Legrand68]

Do you know of any good way of telling which bearing is going bad? Pretty sure it's one in the rear, but definitely can't tell which side yet.

[@chrism9678]

Typically with the car jacked up- you can attempt to wiggle each wheel, when the wheel has play in the hub the bearing has gone bad.

[@Manuelapv]

I have a sound but only when I go in a curve, but when I go in a straight line it goes away. I think it can be my bearing.

[@4614]

@Manuelapv I think this is probably an early symptom. The wheel making the noise may be warm. In my car, even though I heard that noise, there was no wheel rattling.

[@tsunami770]

I know it has been 2 years but that shock absorber was leaking and needed replacement. The rotor was bad too.

[@MVShook]

rotors also look terrible lol

[@snicklefritzthetab8411]

Where can you find the torque specs for all these bolts????

[@4614]

Hello. Numerical information is quoted from Mazda's maintenance manual. The same description was also found on multiple personal blogs.

[@ardiekko4307]

hi pls help me i want video from the rear wheel pls

[@4614]

Hello , I took a repair video of the rear left wheel hub unit . Where was your car broken?

[@lotfisahbani6317]

Bonjour, Les outils utilisés S'il vous plaît ?

[@tsunami770]

3/8 ratchet wrench with deep sockets 10mm to 19mm, cordless impact wrench (high torque) with a set of deep impact sockets 19mm to 35mm, 3/8 inch universal joint, 3/8 inch extension bar, and 18 inch 3/8 breaker bar. Torque wrench 1/2 inch (up to 200 ft-lbs), a wire brush, penetrant oil spray, gear grease, and a new hub assembly. You may need pliers and flat head screwdriver too.

[@arvinbc6062]

👍