Dacia Renault factory integrated alarm hardware activation - step 2

[@sofianemessaoudi245]

Thank you❤

[@bjornaugustyn1212]

Hi Marius Vochin. My S2 Grey connector pin B2 is not giving Ground. I did the software with renolink as you did with ddt4all. The alarm works. I installed the relay and have tested it. My problems is that The Grey S2 connector pin B2 does not give ground signal. not sure what to do from here.

[@miloudbahdi5394]

Hi friend, same problem happened to me, B2 no GND signal from BCM. Have you got any solution yet?

[@bjornaugustyn1212]

@@miloudbahdi5394 no luck at all

[@Борис46]

Такая же проблема, контакт В2 не даёт полного заземления, при срабатывании сигнализации сопротивление между В2 и кузовом падает с 18 до 4 кОм. Возможно это зависит от комплектации, у меня RENAULT LOGAN с климат-контролем.

[@kirullosmaher6398]

The wiring not clear do u have the schematic

[@amratsenkov]

I couldn't understand the explanation. At position B2 of the gray connector should come out + 12V, which are connected to one end of the relay coil, and the other end of the coil is connected to the car body "-". The relay contacts control the horn! Is this the way it should be?

[@bjornaugustyn1212]

B2 is to be ground but its not working for me.

[@lediod]

Merhaba ,şema üzerinde gösterebilir misiniz

[@bahhid]

Shema relais svp