Thanks for sharing your video. Nice to find an easy fix
@williamhawkes71942 жыл бұрын
Great looking pressure kit
@scottk0623 Жыл бұрын
Nice job👍
@tonydelgrego29062 жыл бұрын
Nice troubleshooting and repair
@deanmartin19662 жыл бұрын
Nice job. Thanks for sharing.
@washinton20084 ай бұрын
Is this a multizone mini split if so how can I recover the Freon into the unit from the main line
@NTalache Жыл бұрын
Do you not remove the schrader cores? The access to service valves on these units are horrible for a 5/16 Schrader core remover. Is it easier to just leave them in and use the 45 ball valves like you got here?
@sameermohammed3949 Жыл бұрын
What torque wrench is that that you're using ?.
@eddiegomez36282 жыл бұрын
I have a question about vacuum and getting under 500 microns. Since you pulled under 500 micron mark, Does it matter that the micron numbers jump back up as your getting ready to charge the system?
@NighthawkHVAC2 жыл бұрын
As long as it stays well below 1000 microns you’re good.
@eddiegomez36282 жыл бұрын
@@NighthawkHVAC Thank you for that 😀
@sergiodoordie31910 ай бұрын
My recovery machine is a home depot bucket
@Thomas-iq8zk2 жыл бұрын
Daikins are forever leaking
@jonjensen6036 Жыл бұрын
This is clearly installation error, daikin didn’t make those flare joints..
@kellsieevans38472 жыл бұрын
I have three daikin heads. They all connect to the compressor outside. My two bedroom heads are perfect and blow ice cold. My living room only blows ice cold when they top it off with refrigerant . A week later it goes from blowing warm air for a while then back to cool air but never ice cold like the bedrooms. They came out snd said they found a leak. But a week later here we are and the same thing is happening. What is going on !!!
@bolinsapark Жыл бұрын
probably like an electrical issue. did they fix it ?