Great video...... you are providing a ton of valuable information for fellow enthusiasts! Keep these videos coming!
@OvensGarage3 жыл бұрын
Thanks for watching!
@brianofarrell19773 жыл бұрын
Awesome stuff!
@OvensGarage3 жыл бұрын
Thanks!
@BuildSomethingAuto2 жыл бұрын
I love the little arduino based gauge set, I've been considering doing something very similar (but more permanent 😅) on my swap. Do you have a video on which sensors you used and such? 👍
@OvensGarage2 жыл бұрын
Hi, thanks! I do have several videos on the arduino project. I made a video for each sensor if you look back in my videos and then I have a couple update videos of the project overall.
@solar35513 жыл бұрын
What is that little gauge screen you had on the floor?
@OvensGarage2 жыл бұрын
That's a custom built arduino gauge that I made, it's temporary until I finish my complete arduino gauge pod setup.
@decentgarage3 жыл бұрын
is your injection pump stock? If so you are about to enjoy a whole new world once you tune it.
@OvensGarage3 жыл бұрын
The blue truck I can tell has a stock pump. The red truck I've done 3200 spring, THD fuel pin, M&H timing spacer, and 1/2 turn from runaway on max fuel screw. I need to bring my starwheel up a bit and back out my smoke screw some. I've got too much zero boost fueling and too much fueling under boost right now. We'll see what sort of performance I can get out of it. I think I'll notice quite a difference. I'm hesitant to floor it in the truck right now because it over fuels and smokes too much. Hoping I can get it dialed in a bit more for performance.
@commonrail00752 жыл бұрын
I just got a hx35 from a 98.5-02 dodge it has the cast elbo on it we’re would be a good place to get the exhaust flange to clamp to my stock exhaust
@OvensGarage2 жыл бұрын
Should be the same if it's not some of the exhaust places or diesel shops online sell adaptors that you have to weld on
@owlfalconry36293 жыл бұрын
Truck sounds good did the egt's fluctuate?
@OvensGarage3 жыл бұрын
Thanks, don't have an EGT gauge as of yet..still working on my gauge setup...more to come in the future
@owlfalconry36293 жыл бұрын
@@OvensGarage your truck is in great shape if you do get gauges avoid drilling into the dash or trim pillars. It's nice to see trucks that have been preserved.
@anthonysnyder92282 жыл бұрын
I have the same truck and am looking to order this wastegate. Do you know if I should order the wastegate for the 94-98 or 99-01?
@OvensGarage2 жыл бұрын
I'm not sure as I got mine used, I didn't have an exact part number. As long as the shaft is long enough (I had to cut and thread mine down a bit). you should be okay.
@anthonysnyder92282 жыл бұрын
Preciate it. I ordered the 94-98. We’ll see if I have to do the same