dct actuator adjustment

Dct actuator adjustment. Length depends on type of engine/transmision(see table). Measure the lenght og actuator rod from base. Removed rubber cover on sight hole. Fully retracted the actuator rod then on sight hole, use screw driver(if dont have special tool) to rotate/adjust the rotating nut inside the hole (clockwise nut rotation will retract, and counter clockwise to extend) . After adjustment, fully extended the actuator rod while re-measuring the length from base. Adjust slowly and time to time to recheck length. Note be careful not over adjust the rotating nut, if will dislodge/remove from the actuator inself (If THE HAPPEN DONT WORRY SEE OTHER VIDEOS ON HOW TO REPAIR). Once re-measurement meet the target length. Return rubber cap, and thats it may re-install to transmission.

[@allanvencer6617]

Can you give me the idea wre is the clutch motor 1 in dct transmission

[@moussatoure7494]

Mercis pour la vidéo

[@julesharvey748]

Should clutch fork have play when returning the actuator?

[@Ronald.loleng]

Yes there is yet operating normal, i did relearning at hyundai shop and told me adjustment is good

[@Ronald.loleng]

Mine there is yet operating normal. I did relearning at hyundai repair shop and told me adjustment is good