Deadpool Pinball Machine How To Install Side Art Blades www.pinballpro.com

[@TiltingT]

Slapping some blades on my machine in the morning! Thanks for the tutorial

[@Alpha67Wolf]

With the playfield in, my Tales From The Crypt art blades were easy to put in... My Official STERN art blades for GODZILLA, I played with HELL trying to put them on with the playfield in because the adhesive was so sticky. With GODZILLA I 1) removed the paper backing, 2) cut the paper backing down the middle where the playfield would be in the upright position and cut some tiny pieces off the paper backing at the top of the art blade backing to tack it on AND around the hole where there is a tab on the art blade that has a hole for the bolt that connects the backbox to the cabinet. 3) put the paper backing back onto the art blades 4) Using a rolled up piece of paper the circumference of the hole on the art blade stick it through the art blade and match the hole where the hole for the bolt is on the cabinet.{ perfection 🤓). 5) Tack it down from the tiny pieces you cut from the backing paper and then start pealing from the center where the playfield and work your way to the front getting any air bubbles out along the way. 6) drop the playfield and start pealing from middle to the back getting air bubbles out. 7) put that small circle cut out that goes over the bolt... a lot of people forget to do that. I have the same exact art blade for my DEADPOOL as what is seen in this video....I hope it is as easy like it was for you in this video like it was for my Tales From The Crypt {minus the bolt holes} because it took a few hours to do it my way. It would have been easier to take the playfield out for GODZILLA but I couldnt find the disconnect ... it looked like it was hard wired in.. and I am just one guy and didnt want to lift that heavy playfield and chance breaking something. Gotta go install these DEADPOOL art blades now... wish me luck 😃🧐

[@ChipBee123]

Interested in this for JJP gnr le, but what about scratching lifting the play field in and out of service mode ? Is there enough clearance on gnr for blades?

[@vjackalope2310]

Great tutorial, thank you.

[@henrydahrouge1193]

Is it better to do wet method installation??

[@Pinballprospeakers]

Henry Dahrouge you can certainly do it that way if you prefer, you have seen our recommended method. When installing these for a customer we don’t particularly want to spray water in their game.