Design of tension splice

[@smohideen7874]

Sir double cover butt joint na mattum bolt values a double pannikanum, lap joint ku thevailla right?

[@simpleciviltamil7937]

S

[@smohideen7874]

Sir lug angle video ellaiya

[@gkrishna9841]

Why 12 bolts given while we get 6 bolts in calculation, should it be doubled always

[@simpleciviltamil7937]

Please check the procedure video bro

[@BHAKYA_LAKSHMI_E]

Sir dsse problems podunga sir

[@simpleciviltamil7937]

Enakku puriyala?

[@BHAKYA_LAKSHMI_E]

@@simpleciviltamil7937 neriya sums design of steel structural elements la podunga sir

[@abimanyuabi6348]

Sir intha sum la do=22 eppadi vanthuchi

[@simpleciviltamil7937]

Thanks for your support bro , Dia 20mm naa dia of hole 22 mm thaan bro, pls watch introduction video, this is why I always suggest to watch introduction videos bro, watch introduction to connection video bro or u can see the table no 19 page 73 in IS 800, there it is mentioned clearly

[@kavin.r.k]

sir tension member la lug angles vaichu sum soli kudnga sir plse

[@simpleciviltamil7937]

Ok sure, u can expect that on Monday

[@simpleciviltamil7937]

I checked with 8 University questions paper which I have, in that there is no problem were asked from lug angle method, so if u give the question in lug angle, it may useful to me to solve. You can type that question in this comment section bro

[@benileshrajb965]

@@simpleciviltamil7937 A tension member of a roof thruss carries a factored axial tension of 430KN . Design the section and it's connection , i) without using lug angle ii) Using lug angle.

[@simpleciviltamil7937]

@@benileshrajb965 thanks for your valuable response bro, sure i will make a video on this and let you know ASAP.

[@benileshrajb965]

@@simpleciviltamil7937 Good Work bro...🍀