Designing a 40 meter vertical antenna using MMANA-GAL

[@billpowell5931]

One of the best instructional videos I have seen so far on KZbin for MMANA. You cover the basics very well. Thank you for sharing.

[@luisg6000]

Agree!

[@MAV8865]

The best I have seen so far! nice work..

[@youtubeaccount931]

I installed MMANA last week, this is really helpful thanks

[@siddharth4662]

Looking forward for more education videos... Fantastic Explanation!

[@johnpeterson7264]

Excellent tutorial ! Thanks so much for posting this !

[@MAV8865]

Have you got a full set of videos on MMANA? - due to this being one of the best instructional vedos I have come across. Nice work!!

[@AniruddhaBokilVU3FML]

Yes there are quite few videos on this channel.

[@jsk8973]

Brilliant stuff can you explain how you read the gain/FB chart

[@traveller-nl]

Question: Why is it that when you insert the calculated match (C-parallel: 272.8pF and Series L: 0.55uH) as a load on w1b ,it will not bring the SWR to 1 in the next calculation? Am I doing something wrong here? In my understanding the Impedance (and SWR) should match out on the 50 Ohm normalization when you add the C and L in to the base of wire 1 (in the lower right part of the geometry screen). But, somehow it's not matching. Yes I have "Use load" selected. I can see it do something, but not quite matching the feed point to 50 Ohms.

[@khoyfungpiong9128]

Do you have video for designing a 40 meter EFHW antenna using mmana-gal ?

[@MrPaulstrivens]

Excellent instructions on how to use this design software I am a novice and am looking for clear guidance on this subject and this is it 👍

[@AniruddhaBokilVU3FML]

Thank you!

[@CE3FJK]

is there a way to change the length of the radials?

[@stefanodonati-iv3ips561]

Nice... will be put to work in the next few days. Thanks !

[@AniruddhaBokilVU3FML]

Thank you for watching!

[@yashodhansatellite1]

Thanks for sharing..much needed

[@Tom59xl]

Thanks DL8DBW