Deutz-Fahr no heating

[@hugohammarberg6631]

Speed 1 and 2 are controlled with resistor packs. Speed 3 and 4 are controlled with the relays. The relay to the left is for speed 3 and the one next to it is for speed 4.

[@sol_uble7121]

Where did you purchase the fan motors ?

[@MOP_LV]

Just changed both blowers on my 6 series Agrotron 150. Mine were different (came without the bottom plate), but while searching i came across this one (Part numbers: K92226, 0.010.2535.0, 9.2226 ), looks quite the same but verify yourself. Also, get yourself new resistors, especially if you`re going to rip off the right side panel. Edit: (Important heads up for anyone about to do this) Avoid the mistake this guy made, 2:32 , the fans are supposed to spin in opposite directions, but the fan blades are pointing the same way, also, 2:53, might be a recording glitch, but looks like the fan is spinning the wrong way, top opening is intake, side is exhaust. If you run in these issues, you can reverse polarity of the motor AND/OR reuse the old fanblades

[@rickyj2010]

Perfectly explained

[@prki-rq9nf]

Lijep pozdrav.. Interesira me cijena tog ventilatora? Meni jedan jako bruji.... U pitanju je deutz fahr agrotron 100 Hvala

[@meisterraul]

your ac radiator looks very bad, why?

[@stjepanhuzjak]

Because someone bodge it already ... 😁

[@Max-grantlermann]

Thanks, i also have an 135 Mk3 it is such a good machine. But disassembling is horrible! Did you chanched the AC Conditioner? It looks so fucked :D

[@stjepanhuzjak]

Tractor is amazingly good, check my channel and please subscribe I have more videos. About Ac cooler it was like that, but it's working no need to replace it just top fins were bended... I used compressed air to clean it as much as possible to get decent air flow through