Diagnosis of issues in Yezdi Adventure using Fuses

In this video, I take you through the process of diagnosing electrical issues on my Yezdi Adventure by checking the bike's fuses. Whether you're dealing with non-functioning lights, a dead horn, or any other electrical problem, this guide will help you identify and troubleshoot the root cause using the fuse box. Watch as I share tips on locating the right fuses, checking their status, and understanding the role of each fuse in your bike's electrical system. Don't forget to like, share, and subscribe to 'Baby Adventure' for more DIY motorcycle maintenance and riding tips!

[@IAmAnAlbatross...]

Also there is a sticker under the fuse box cap. It says which fuse for what and its Amp rating.

[@baby_adventure]

@@IAmAnAlbatross... Ampere rating is okay but their purposes are not clear on the fuse box sticker. So I chose this for video to show

[@IAmAnAlbatross...]

@@baby_adventure you could have add that point.

[@baby_adventure]

@@IAmAnAlbatross... Yeah correct, I thought it's confusing to show two things which aren't conveying the same. Covered the fuse box sticker in a short video long ago

[@travelndeep]

Very very very useful bro Great video🙌

[@baby_adventure]

Thank you so much bro🎉

[@vaibhavnegi645]

Hey , I did not 1200 km ride and after completing I got engine light I didn't pay attention to it at that moment but after a while I started to notice the engine was starting to stall a lot so, I sent it to service centre and they are saying my MC is damaged, I don't know what's that , do you know anything about it , also the compass is looking nice where can I get it from

[@baby_adventure]

@@vaibhavnegi645 M/C stands for machine, I don't know can you explain it what they are pointing to.

[@vaibhavnegi645]

@@baby_adventure I don't know cause I was not at home so my father took it to the service centre and they said it was damaged and needed to be replaced and they don't have a spare for it for a week ,until then avoid riding any further the rpm were also fluctuating like even after releasing throttle and pressing clutch completely or in neutral, rpm will be stuck at 2100 rpm untill u start moving again

[@baby_adventure]

@@vaibhavnegi645 yeah, it seems to be failure of tps sensor, throttle position sensor why these bikes are equipped with this faulty sensors. I researched a bit the only solution is replacement

[@sanjib2k24]

I have a different issue.. Whenever my bike goes through some rough jerk.. Like crossing the minonr speed breakers with a little speed.. The bike gets imbalanced.. After some time it fixes automatically.. Can u plz tell me whats the cause..? Is it normal?

[@baby_adventure]

@@sanjib2k24 check the alignment, tyre air pressure if all is okay, braking if any and last bearings. This flow of diagnosis will solve the problem. Look for front suspension travel too