Tool Time - Using Lower Steering Stem Removal & Installation Tool (Video)

[@ranflstci1357]

That's the best demonstration of this tool I've seen yet! Well done!!!

[@JamesBond-kb1wl]

Nice brotha. I've been trying to figure out how to get the bottom race out. Thanks

[@satishvasane6812]

Good job bro thanks from Dhule, Maharashtra, India

Stem removal and stem bearing removal are very different things...

[@whiskywhippet]

Thanks for that. Does this work for non taper bearings too?

[@robank3900]

I have that tool and to me it seems the driver adapter should be the other way so it just contacts the inner race of the bearing. The way he shows it you'll be driving the outer cage a bit

[@adamtremblay8439]

Do you have a video on how to remove and replace the whole stem?

[@lewiscunliffe1051]

Adam Tremblay usually have to be pressed out mate, shouldn’t cost much if you can take your lower yoke to an engineering/mechanic shop 👍🏻

[@randyhendrickson8455]

Read the directions and don’t just watch this video like I did. Fails to mention there is a round protector plate that needs to go in the tool before putting it over the stem.

[@phillipjeffrey8567]

Great tool. I don’t understand why you wouldn’t have another thread with a nut high and wind nut down pushing bearing on rather than hitting new bearings with a hammer.

[@lewiss66]

Hi , Thanks for the video. I wonder if this tool can be used for other brand of motorcycles. Could you tel me what is the length of the tube and inner diameter as well as the washer. Thanks

[@LyonhartZ2]

He Lewis, go the Motion Pro Website

[@julianarodriguez3635]

Can I use this tool on scooter let me know thanks

[@julianarodriguez3635]

How much is the tool

[@forevercomputing]

This looks too short for my needs.

[@rolandos64]

This a bs video. I understand there are more ways than 1 to do things. But using a press to remove the stem is much easier in my eyes. Just my 2 cents