Digitrax DCS52 Zephyr Tips Video Part 2 - Resetting a decoder

[@mer2705]

Thank you very much!!!

[@canadian-l4q]

finally, someone i understand,..thank u so much for help sir

[@DigitrainsLtd]

You're welcome. We're pleased you found the video helpful.

[@cczinn7670]

Thanks for the information, new to Digitraxx and learning the ropes.

[@rudiniederkorn9078]

Clear and concise, thank you so much.

[@PaulJohnson-cg6lo]

I came across this, this morning and now have tried successful 😊

[@DigitrainsLtd]

Pleased you found it helpful 🙂

[@johnrinehart1280]

Thank you so much your directions and screen pic are the best. Others could learn a lot from you

[@jeffreyrule8143]

Thank you very much.

[@poochie49]

Is the Digitrax Zephyr DCS50 capable of programming the new Tsunami2 decoders? My unit works fine with my other DCC locos but I can't seem to program the Tsunami2. Or maybe I'm doing something wrong.

[@57bigjon]

How do you select programming track or do you have to disconnect the main track

[@DigitrainsLtd]

You need to wire in a separate piece of track to the prog a and prog b outputs on the grey terminal block.

[@57bigjon]

Thank you for your help

[@nnoscc5231]

I got a message at the bottom that says “No decoder ACK pulse” After changing the CV number and data

[@MRASTONVILLA55]

Hi can you do a video on how to change the cv my trains take long to come to a stop.

[@DigitrainsLtd]

Altering the value for any CV can be achieved using this method on the Zephyr. Changing the values for CV4 will alter loco deceleration rate. 🙂

[@MRASTONVILLA55]

@@DigitrainsLtdthankyou I find it hard to follow the manual would it be possible to do a video on this controller on how to go about altering some of the cv s only I've only just bought this model.