Dini Argeo DGTQ (1).วิธีการสอบเทียบน้ำหนักโดยการกดปุ่ม

"DGTQ": DIGITAL WEIGHT TRANSMITTER/INDICATOR
Multipurpose weight indicator/transmitter for panel mounting, 4 dependent or independent channels for direct reading and diagnostics of each connected load cell. The wide range of available interfaces, makes it easy to integrate the weighing with any automation system. CE-M approvable (OIML R-76 / EN 45501).
---------------------------------------------------------------
MAIN FEATURES
Easy to use 5-key waterproof keyboard.
Highly efficient red LED display with 6 13-mm digits and 6 LEDs for showing active functions.
Case for panel mounting in Abs according to DIN standard, 96x96x80 mm (lxhxpx). Perforation 90x88 mm (lxh) for panel mounting.
Calibration, Set-Up parameters, configurable from keyboard or from PC with DINI TOOLS
Up to 10.000e or multirange 2 x 3000e @ 0,3 µV/e in CE-M approved version for legal for trade use.
Up to 1.000.000 displayable divisions with internal resolution up to 3.000.000 points.
Up to 8 signal linearization points with DINITOOLS (3 from keypad).
A/D 24-bit sigma-delta conversion, up to 400 conv./sec. autoselect.
Connectable with up to 8 analogue load cells with 350 Ohm input resistance.
Management of a digitally equalised 4-cell weighing system or management of 4 independent weighing systems.
Master/Slave management (up to 4 Slaves / 1 Master).
-------------------------------------------
MAIN CERTIFICATIONS
EU Type Examination Certificate (45501:2015)
OIML R76
OIML R61 - MID
OIML R51
------------------------------------------------------------------------------------------------------------
www.kascontrol....
KAS CONTROL CO.,LTD.
90/4 ถนนท่าข้าม แขวงแสมดำ เขตบางขุนเทียน กรุงเทพมหานคร 10150
90/4 Thakham Rd., Samaedam, Bangkhuntian, Bangkok 10150, Thailand
Tel : [phone] Fax : [phone]
www.kascontrol.co.th Email: [e-mail]

[@francisdagba4773]

Good Morning Sir, thanks for the tutorial. i have a question, I changed the new load cells and when I turned on the display this error message appears "oUEr." Can you help me please?

[@saleskascontrol1383]

Please set the new "rAnGE" for the new load cell capacity.

[@mikahwetan2124]

Great tutorial video here. I have a question, why after save and restart my indikator always show 0. I had not yet removed the weight. Please help me. Thanks.

[@saleskascontrol1383]

Please check this function. Auto-0 > Auto-Zero at the start up Change it to "disabled"

[@mahdaouihamza1389]

Hi bro Can you sent me manual pdf