DIY Adjustable work table

A look at our version of an DIY adjustable height work table.

[@jagboy69]

That's bad ass... When can I pick it up and take it back to Texas?

[@barrylukebuilds7894]

Well, I guess everything has a price. But right now it is a little high. But thanks!

[@JB-xi2yv]

Curious on the screw type used to raise/lower the legs, but I guess I'll have to experiment.

[@barrylukebuilds7894]

JB Defiantly an ACME thread rod. They are designed for high side loads. I got mine from Mcmaster Carr. Good luck on your build! Barry

[@DavidGonzalez-ts9xf]

Awesome table... can you provide the list of parts from McMaster?

[@barrylukebuilds7894]

David Thanks! Pretty hard to remember what I did yesterday let alone a few years ago but maybe I can help a little. I started with 5/8 Acme rod. So all of the telescoping hardware (nuts and bearings) should be ordered to fit that. Then I think I used a number 25 roller chain so naturally the sprockets you chose should be for a number 25 chain. I hope this helps a little and good luck! Barry