DIY Boot/Glove Dryer for ski and snowboard boots: Easy and Cheap

[@JJJK2121]

I like your “fancy festool track saw” 😂

[@TheSnow150]

The laidy peeking in on you was funny

[@MathjSteed]

I like the fancy festool track saw.

[@timshanahan1]

Great project! I used hockey tape around the edge of the 3/4" pvc. I just put a few wraps around the edge and jammed it into the holes. It seems sturdy.

[@wwgbert]

Nice work! This will work perfect to make a bench next to the front door and have our coat rack and boots all in one place. Thanks for posting!

[@andrewhuntsman8723]

Thanks! Let me know how it turns out!

[@dadfacts2371]

Very nice! Just do a little work with volume averaging with the music.

[@travisgillespie2819]

Very cool, thanks for sharing 👍

[@baJR5721]

Awesome job!

[@andrewhuntsman8723]

Thanks!

[@NancyBaabe]

This is awesome!! Thank you!!

[@ryanjwelsh010]

Great job!

[@DorianBarcusRealEstate]

Great video!

[@sebastienthibodeau5556]

Very nice job! Are you satisfied with the 110 cfm fan power? and could you tell me what is the diameter of the pipes for the mittens? Thank you, you are inspiring!

[@andrewhuntsman8723]

Hey Sebastian, Thanks for the kind words. I am happy with the amount of airflow from the fan. It drys out wet equipment in a couple hours which is what I expected. The only issue is it would be a bit noisy if it were in a small living space. I keep mine in the garage so it's not an issue. The PVC is 7/8in or 22mm outside diameter or 5/8in or 15mm inside diameter. I think you could be flexible with the size of this. I just had it lying around.

[@alexharvey3594]

Great design. How did you attach the hose to the box?

[@mntsportr7615]

What was the overall length? Seems like going with 12-14” in length, per pair of boots, would accommodate with ample room. 4’?

[@andrewhuntsman8723]

Exactly it’s 48” long and about 5”x5” height and depth depending on the fan you have

[@skiutah]

@@andrewhuntsman8723 Just build mine a couple of weeks ago. I ended up putting 1 fan at either end, used the same Infinity fans. Works great. I just need to setup a timer .

[@andrewhuntsman8723]

@@skiutah Nice! I like the two fan system!

[@Joshjohnston2009]

Cool design. How did you secure the fan in the box?

[@andrewhuntsman8723]

Great question. I uses two small sheet metal screws and some plastic strap around the fan assembly. Honestly the friction fit when the box was assembled would be plenty.

[@brothersaerotech4209]

can you share the dimensions?

[@andrewhuntsman8723]

It’s 5.3” x5.3”x 48”