DIY Ceramic Coating | Step by Step How To With Gyeon (Pt. 2)

[@keshoremooralie2376]

Gyeon Can Coat. The good stuff. I was able to get 2years+ on a daily driven from Can Coat 2nd gen. Took me 45mins via seude applicator and pipette. Gyeon Can coat can easily out perform some of other brands using this method . Can Coat EVO makes it even easier.

[@MrAbword]

Love all the guys complaining about not polishing before a coating and not polishing after claying. Most customers could care less. As long as the paint is cleaned, decontaminated, and hit with a prep spray you can coat anything.

[@stephenlouden480]

I did this on a new light grey Audi Q7. and some other detailer guy pulled around n was like "bro you v didn't polish?!" ugh the coating won't last. 8 months later and a maintenence wash every 2 to 3 weeks and CanCoat is still like day 1. I stopped the other detailer guy driving by and asked him why the coating is still as good as ever?.. ughh, umm... I dunno. 😆 I said.. because you don't necessarily need to polish unless the clear coat requires it. WAKE UP PEOPLE. great job and videos. you guys are the best!

[@larrysing]

Gyeon CanCoat is great stuff! Thx for the review!

[@WhiteBeardDetail]

I want one of those gyeon hats. I offer can coat for the budget friendly clients.

[@taylorshiver3284]

Did you ever find it? That is an awesome hat.

[@chrissimon8403]

At 13:56 it looks like the front windshield is all streaked?

[@Outrage82]

they filmed the removal of the windshield product after doing the can coat, as they needed 15 mins for it to set before wiping it off.

[@KicoMendoza]

Would LOVE to see a demo vid of "outdoor friendly" Can Coat actually applied outdoors! A lot of is SoCal enthusiasts don't have a garage to coat in.

[@MrAbword]

All of Gyeon’s consumer coatings can be applied outside. Of course it’s just always easier and better to apply in a garage or anywhere out of direct sunlight.

[@leftyo9589]

if i have to heat the tire to put on tire slime, it had better last a very long time.

[@Solothegr8]

You’d be surprised lol works great. To be fair you can skip the heating and it still does great.

[@MrAbword]

In order to get the most out of any tire dressing, it’s best to heat the rubber up.

[@chrissemsch8781]

After you clean the tires, face the wheels to the sun. Wait 5 minutes then put the tire stuff on

[@seventysschev]

Only way to screw up QuickView is detaching the coating reservoir from the applicator pad by over tightening…not that I’m speaking from experience 😬 Both of these products are killer though. I’d recommend wearing some kind of mask for Can Coat-its solvent smell is pretty powerful.

[@neilwalker5041]

Lol at your either slow or drinking beer! How many beers does it take to leave a high spot in cancoat?

[@eca7773]

Can't wait for the weather to warm up without it raining here in Germany so I can use what I learned here and coat my car in can coat.

[@Vince-ur7oc]

Is this ok to apply on sections with PPF?

[@nathansaam5715]

Absolutely PPF, Paint, and Trim as well.

[@bmarvinb]

He, great video! I have a question, after 1 year, before next application of can coat, what prep should I do to the car?

[@tylerboss7792]

This channel is 🐐🔥

[@jaimcr]

When will Gyeon come out with an air freshener that smells like Gyeon prep?🙏🏾

[@derekb5749]

Did you do the window first, in the can coat video you can see all the stroke marks on the glass.

[@stevemk4st649]

Yeah either the inside of the windscreen is dirty or the glass application was not good at all. Looks a right mess.

[@themachine8009]

In my experience anytime I coat a glass window, it always squeaks. I just use stoners. I guarantee u that windshield is gonna squeak.

[@barryseifert6053]

So they go through all the prep to get the oils off and the guy keeps leaning on it with his bare hands and arms .

[@mathglitch4543]

All that with the supervision of the guy from Gtech

[@quintenqfinish]

Imo, always polish before coat. Polishing open ups the clearcoat, and provides more gloss. Coating afterwards will be the cherry on the cake. If you don’t polish, the coating ability’s, in terms of shine, will not be to its full potential. Also, claying can leave marring on the paint, which will also affect the gloss effect.

[@nc.detail]

Define ‘open the clear coat’

[@joelpasserell4525]

Claying with proper lubricant and an ultra fine perforated clay towel can & has be done without marring the paint. Have done it multiple times with no problems when checked with scan light after. All in the products and technique. Don't remove any more clear than you have to if it doesn't need it. Mfg. are putting on less and less of it now-a-days so it's best to polish when it needs it, not just because it's a step a process.

[@j-sonS]

Can coat is in the mail to me. Seems like it's similar to fast finish product.

[@billbuss7542]

Can’t you use Cancoat on the windshield and windows also?

[@carlosarroyo5262]

Would be something to have the vehical sit out side while the paint finishes curing then add the tire shine befor pulling it into the gurage for the night.

[@Magna2D]

Is there a Gyeon product for Matte wraps and matte powder coated wheels? You have sold me on the products but I have one car with all matte finish and don't want to make it glossy.

[@mikeytheref3546]

The can coat comes with 3 spray, nozzles the detail store I bought it from said that after one use of that nozzle, you gotta throw it away because the ceramic coating crystallizes inside. So how can I get 10 to 15 cars from only three spray nozzles that I could only use once per time

[@Join0rDIE1776]

Use your head dude. Use some hot soapy water and spray some through your nozzles after applying product… the lack of common sense in this world is truly sad…

[@dcz4845]

I did a prep on my 2020 black Accord. Ended up with high spots. ANy suggestions on removing Q2 Cancoat? I reached out to Gyeon on 4/6. No reply. One channel suggested sanding with 2500 sandpaper. Seemedn extreme..

[@ChicagoAutoPros]

Definitely don't use 2500 sandpaper. Have you tried this product: bit.ly/3KZqKhQ

[@dekoeneridder2452]

Shame he says putting on gyeon view on your wipers it keeps it from juddering. I found that by coating windshield AND wipers (with the bottled version of q2 view) it DOES judder. Imoh most likely because it works SO well , with one wipe the surface becomes so dry/clean it adds to the friction of rubber on glass , therefore judders. Any one else with this experience?

[@videomaniac108]

I love Gyeon products and have been trying to use its Prep, but the state of California won't allow it to be sold here, I tried through two vendors to get it without success. Is there another good prep product that is similar that I could use, or should I just go with my homemade 15% isopropyl alcohol solution in distilled water.

[@Dlepe14]

I was having the same issue in California, so I went to Amazon instead of Gyeon website, and I got prep and can coat delivered

[@videomaniac108]

Thanks, I'll try that.@@Dlepe14

[@fernandoperez5435]

What’s the cure time and could you leave the car outside if I don’t have a garage

[@MrAbword]

I’ve left it on for as long as 10 mins before and it levels off really easy. And yes you can leave outside

[@damianopach4045]

i m confused is Gyeon a brand from South Korea or is it a International brand?

[@evan_cloud9]

Didn't realize that Tom Delonge is a fellow detailer!

[@ChicagoAutoPros]

😂

[@autorecon8744]

What’s your go to for hand waxes these days ?

[@SlingSuds]

The windshield looks crappy, you can see all the smears when they are coating the rest of the car.

[@1Nevergone]

No good after shots once it was all done???

[@SkilledByDesign]

How long does the bottle last after opening?

[@laurapalmerTDGE]

Given that the bottle is closed, the time is indefinite but not unlimited. Pay particular attention to the sprayer / nozzle that must be clean and then you will come a long way. 10:22 / 22:07 Have fun with it if you consider purchasing it.

[@hectorsantos5565]

💪💪🙌

[@1stfrompuertorico568]

Nice!

[@robertdelvecchio7438]

lots of Kool-Aide consumed in this video - but i appreciate the information nonetheless

[@davidboyce6427]

Let me get this straight. You can coat a ham sandwich? 👍. Just wanted to make you guys laugh🤣

[@smitttty]

why do the windows all look horrible and streaky

[@alro3227]

Alot clients with new cars they don't want polish. Just want ceramic....

[@henriquett8232]

You don't need to polish just like you don't have take a shower, just spray some perfume and your clean. Nonsense

[@Solothegr8]

If you know the vehicle doesn’t have any other form of protection on and you’re happy with the finish a panel wipe if sufficient prep.

[@themachine8009]

😂😂exactly

[@rodneytatum6920]

Most people want their car ceramic coated for ease of maintenance. I like level swirl free paint even if I put spray wax on my car. People can have different desires than us and buy detailing products.

[@denzeljackson6505]

I don't get it u go through all that prep besides u never do polishing why not use a proper ceramic coating like mohs evo & use can coat as a maintenance spray I'm talking from a guy who's doing his own car at home. I get url want to showcase can coat

[@AntLive29]

I would use a real ceramic coating but then again it’s on a basic white car

[@gilibuzaglo6316]

this video actually intends to deter you from diy, so many products involved and so much work, easier to let a workshop do it

[@Kahlon-s7u]

Turtle wax seal n shine prolly gives same results for $10 😊

[@willsrestorations]

I always laugh when some detailer uses the same rag to apply a product and then uses the same rag to take it off, always always use two different towels for this process. By the way my man where did you get this guy in your video, he sounds ignorant, if he was a spokesman for my company I'd have to fire him he sounds like he has no idea what he's talking about and as he's talking he doesn't seem sure of himself at all.

[@Vc12383]

Towels have a multiple sides

[@willsrestorations]

@@Vc12383 yeah no kidding Sherlock. Should always do two towels but you do whatever you want.

[@vincentmiano342]

Detailers have ego and there are thousands of ways to do a job and there tons of situations but results will be the same. Do you whatever satisfies your ego

[@willsrestorations]

@@vincentmiano342 you sound ignorant, there aren't thousands of ways of doing things, there's either a right or wrong way, so please go run and wax the little kids bicycles in your neighborhood. Your clueless

[@synovium]

After cleaning the windscreen and supposedly wiping it clean, significant streaking was seen while the person applied the ceramic coating. Why is that?

[@davida7713]

its utter garbage and very easy to leave spots too. not quick not slick finish either and very average plus it stinks . this video steams paid ad

[@idontcaresapo8233]

What about as topper on an existing ceramic coating? I want to do a refresh on my truck whiowas coated 1 year ago

[@Aestheticsauto]

How long does Quick Veiw last?