In this video I explain my Crank but No Start issue with my 06 Buick Lacrosse 3800 Series III. It finally gave a P0335...Also I explain how to use the Harmonic Balance puller to access the Crankshaft Position Sensor.
Пікірлер: 54
@gregsmitz63102 жыл бұрын
Great video, my Lacrosse started stalling out just after starting it but only once in a while. I thought the gas was the issue till one day while driving on the highway, it just died. After getting it towed to my favorite shop, they found the same problem. I have a 2007 Buick Lacrosse that I use for work.
@kevinwells4888 Жыл бұрын
I'm not having this problem yet but thanks to you I'll be ready when I do. Great job.
@1418yamil3 жыл бұрын
Thanks for the detailed information!👍👍
@cedmac33663 жыл бұрын
Glad to help 👍🏾👍🏾
@mndronenut51092 жыл бұрын
Thanks for sharing there's not many videos on the 2006 Buick lacrosse and the ones I have watched shut off video before doing the replacement then turn on after it is installed. Not sure what they were thinking the install is most important part. Thanks again!!!!
@cedmac33662 жыл бұрын
yep...I made this video specifically to help with that. Please reach out if you have any other questions...I would love to help. 💪💪
@zhodge04 ай бұрын
It helps me. thank you.
@cedmac33664 ай бұрын
Glad to help 😎
@karenriley4208Ай бұрын
I have a 2009 Buick LaCrosse CXL. Garaged, don't drive it a lot, but it's been reliable. Had brakes done and four new tires installed. A couple days later, my car doesn’t start. Took to repair shop, was told the ignition control module needed to be replaced. Had the ICM replaced. Still won't start. Was told ignition coils needed to be replaced. Had this done, car still won't start. Out a lot of money, had car towed. Looking for a solution.
@cedmac3366Ай бұрын
@karenriley4208 start with reading the engine codes. If you did that what codes cames back?
@paulsosa18722 жыл бұрын
I have a Buick lesabre with the 3800 been having intermittent crank no start I'm suspecting this is the problem with the crank sensor.
@jaytube2272 жыл бұрын
Thank you sir!!
@jaytube2272 жыл бұрын
Do you have to reset the position sensor data after install or it just works?
@cedmac3366 Жыл бұрын
Good question...No need to reset anything...it just works like it should
@youngdeity666 Жыл бұрын
Is there a relearn procedure with an 06, Buick lacrosse I installed new sensors that did not work (EBAY) put my old ones back in then it started right up! I’m duped brother please help
@cedmac3366 Жыл бұрын
I did not have to do a re-learn. It started up soon as I put everything back together. What issues are you having?
@cedmac3366 Жыл бұрын
Also...what sensors did you replace?
@youngdeity666 Жыл бұрын
@@cedmac3366 prior to me installing “new” camshaft/crankshaft sensors the car would stall out. Crank no start at times if I’m on the freeway the car would not cut off but if I was on the streets or came to a stop sign the car would cut off! The auto zone brand Duralast is most current one that I have BUT THE CAR STILL CUTTING OFF. I even sprayed the electrical connectors with some CRC electrical cleaner. I’m baffled as what to do. Lastly I’m dealing with intermittent cut offs.
@youngdeity666 Жыл бұрын
@@cedmac3366 additionally when I inserted those fake ass sensors from eBay the would only crank! Just cranking then I put old ones back in to troubleshoot my issues and like I said I put old ones back in they started right up! Which tells me that those sensors was no GOOD. Oh also no check engine lights at ALL. But when I went to auto to use there advanced ODB reader the results came back cranksenors issues respectfully.
@cedmac3366 Жыл бұрын
@Young Deity ok...I believe you triggered the Crank/Cam position sensors when you tried to replace them. So now let's move foward to the intermittent cut-offs...First my vehicle never just cut-off intermittently. Either it started or just cranked with no start. For you I would try to unplug your Mass Air Flow and drive it around and see if it cuts-off. If not, then replace it.
@nonapplicable68852 жыл бұрын
Do you have to take off the belt
@cedmac33662 жыл бұрын
Yes you have to take off the belt
@supernintendo7579 Жыл бұрын
BRO!! TYSM!!
@cedmac3366 Жыл бұрын
Did you fix yours?
@LIFEOFDARRICK2x2 жыл бұрын
05 lacrosse mines doing the same thing I gotta try it like 5x for it too work
@cedmac33662 жыл бұрын
Yep more than likely this is the cause...hope this fixes your issue... keep up updated 👍🏾
@brianfraser782210 ай бұрын
My 2008 buick lacross ,crank no start,,,,,changed crank sensor,,,,,still crank no start,,any idea ?,,,
@cedmac336610 ай бұрын
Check fuel pump. You can try some starter fluid in the throttle body and If it starts then dies again, your fuel pump is bad
@cedmac336610 ай бұрын
Also...are you getting any trouble codes?
@cedmac336610 ай бұрын
Any updates?
@brianfraser782210 ай бұрын
@@cedmac3366 still crank ,no start!,,,
@cedmac336610 ай бұрын
@@brianfraser7822 is your check engine light on?
@905maxp Жыл бұрын
Would love to talk ced I have crank no spark on a 3800 s3 09 allure
@cedmac3366 Жыл бұрын
Any questions? Reach out and I'll try to help.
@brianfraser782210 ай бұрын
My 2008 lacross cxl does same,,,
@mikewalz92722 ай бұрын
I have a 2005 buick lacrosse cranks but wont start ive replaced camshaft sensor
@cedmac3366Ай бұрын
@mikewalz9272 have you scanned it for any codes?
@905maxp Жыл бұрын
Ced man I have an issue with a 3800 can we talk my man kind regards sincerely Maxwell
@cedmac3366 Жыл бұрын
What issues are you having
@905maxp Жыл бұрын
@@cedmac3366 hey my man it was a no start lots of crank issue on a 09 allure I used your video and ordered the proper puller I completed the job today man she started right up the cam sensor smelled like a burnt circuit board when soldering so I was assuming it was toast by your video and luckily it was I appreciate the post and the reply my man
@cedmac3366 Жыл бұрын
@905maxp That's was up!!! I'm glad it worked for you!! The reason I made the video was to help. Good job and thanks for posting an update!!! 💪🏾😎💪🏾
@905maxp Жыл бұрын
@@cedmac3366 your welcome my man look me up if ever in Niagara Falls Ontario Canada Maxwell Pacey
@tylerirelan32462 жыл бұрын
I have an o9 lacrosse last year 1st gen. I have redone EVERYTHING myself. Anyone need help lmk. I'll make videos. Doing the cps today!
@cedmac33662 жыл бұрын
💪💪
@supernintendo7579 Жыл бұрын
Is it the same as the 2007 lacrosse? 3.8
@cedmac3366 Жыл бұрын
@@supernintendo7579 yes it's the same
@BIGGDOGGBAMABABE95 Жыл бұрын
I have a 07 Buick lacrosse and I cranks it up and it cranks, but it doesn’t drive or reverse .. but it’s running fine