Light fixture: Commercial Electric 1 ft. x 2 ft. White LED Edge-Lit Flat Panel Flushmount Link to the light: www.homedepot.com/p/Commercial...
Пікірлер: 23
@squigglyphrank93484 ай бұрын
Thanks my dude. This helped
@Drewcifer19742 жыл бұрын
Thank you so much for this video! I just installed the exact same light in my bathroom and it looks amazing.
@GregLopez754 жыл бұрын
Awesome! Thanks for sharing. This vid was a huge help. Cheers from Dallas TX
@MrGeminijay3134 жыл бұрын
So you just tossed the toggle wings that suppose to be your support
@TomNouri3 жыл бұрын
Ours doesn’t sit flush, I took a 48” level to the ceiling and it sat perfectly flush but this fixture once on the mount sits with about a 1/4” gap on both ends. Mounting plate needs to be longer with locking mechanism that pulls fixture tight to ceiling.
@woodchip27822 жыл бұрын
Manufacturers of ceiling mounted electric gadgets should add coiled wires to their kits. I don’t know if it exists but I really think it could work.
@monicamarks46886 жыл бұрын
I’m freaking out. I had two 2’x2’ lights installed in the kitchen by an electrician. Didn’t notice at the time, but there are tons of fingerprints inside, so I have to take them off and clean them. I’m worried I won’t be able to get them back on. We shall see. This video at least gives me some idea how they go on in the first place. I replaced the chandelier and some other normal ceiling lights but I’ve never worked with the LED panels. I wish me luck.
@UncleFjester3 жыл бұрын
Feit Led Panel @ Home Cheapo Fits tight to the ceiling
@brianreip4113 жыл бұрын
how would you install this if there is a open area above the light the width and length of the light? I am replacing a incandescent fixture in the soffit with a 1 by 1 led square panel.
@xcmskim45 жыл бұрын
i noticed that the light is bleeding at the top of the fixture towards the ceiling from the fixture if you view from the entry door. Also it looks like theres a small gap between the wall and the fixture.
@xdalhousie2 жыл бұрын
want to change light mode - how do I get the panel off??
@mendozaleedap6 жыл бұрын
What were you screwing into? I realize the fixture is lightweight, but are you concerned that the screws may pull out since you didn’t use the toggles?
@diyhustle5 жыл бұрын
I was screwing directly into the studs. I didn't realize that I left this part of the instructions out though. Thanks for commenting!
@cupdejello4 жыл бұрын
@@diyhustle that box that you screwed the plate into is going to be strong enough for those lightweight little things. I think the corner screws are more so that the fixture stays flush to the ceiling.
@pf19504 жыл бұрын
well done
@sonny19776 жыл бұрын
Very Nice
@oldgar94 жыл бұрын
Last screw you installed went through sheetrock and not a stud, not good.
@pietdelaney2 жыл бұрын
Made to look too easy. Surely you had to look for studs or use Molly's.
@DonBryantPhotography4 жыл бұрын
This fixture is a bitch to mount
@oreoyeliab7 ай бұрын
I agree. The concept is good but trying to slide the light fixture onto the mounting bracket takes a lot of patience!