Do I need to buy a helping hand/third hand tool to hold the pcb board? And can I just do this with no gloves on any floor/surface? Thanks
@user-ve1cc6qn6t4 жыл бұрын
You don't need helping hands but it is way easier with them, try soldering on a table or on the floor and make sure if the solder doesn't drop onto anything else.
@earthpotato51432 жыл бұрын
You can try to cover the surface below with paper or something and tape down the pcb board to prevent it from moving.
@lynx8733 жыл бұрын
I want to change mouse into really soft click bcoz I have muscular dystrophy
@orlypalomar4 жыл бұрын
I recently replaced the microswitches on two of my mice and they're now like brand new. The only thing I'd do differently in the video is to give the mouse a thorough cleaning. It looked filthy, inside and out. Not passing any judgment because my mice also do get dirty after some rigorous use. But since you're already servicing the mouse, it shouldn't take any more time to whip out a paint brush to clean the inside and some mild cleaner on a cloth to clean the outside.
@TheSmileysCrew3 жыл бұрын
How do I find out my mouse’s nominal actuation count rating. I dont know what switch to buy
@p1nky023 жыл бұрын
All switches fit every mouse
@TheSmileysCrew3 жыл бұрын
@@p1nky02 ok 👌
@mckevindauntless6983 жыл бұрын
Boss matanong ko lang po? Ano po gamit niyo na soldering iron? At ano po tawag yung tape na 3M? Maraming salamat po
@marcelanno85804 жыл бұрын
did same on my Steelseries Kinzu v1 :D
@cajamanual67134 жыл бұрын
5 años con este mouse y no me ha dado ningún problema.