Congratulations! Very nice work. Hope that you can enjoy enjoy your pop-up roof soon and show us the final result.
@DefenderCanada2 жыл бұрын
Finally made a part 2... kzbin.info/www/bejne/qJfXnIipgseKba8
@Zavalik3 жыл бұрын
Nice! Looking forward to see part 2… I’ve seen photos of you using the roof on the car… it looks great!
@DefenderCanada2 жыл бұрын
Finally made a part 2... kzbin.info/www/bejne/qJfXnIipgseKba8
@BritannicaRestorations3 жыл бұрын
Looking good! M
@surolandy3 жыл бұрын
Good job iam waiting part 2
@DefenderCanada2 жыл бұрын
Finally made a part 2... kzbin.info/www/bejne/qJfXnIipgseKba8
@francescogiani773 жыл бұрын
Very good job!! When will you release part two? I bought a 109 blind roof (the 109 doesn’t have the round corners on the Wind screen) and I’m waiting your second part to start my work!!
@DefenderCanada2 жыл бұрын
Finally made a part 2... kzbin.info/www/bejne/qJfXnIipgseKba8
@georgetee12 жыл бұрын
waiting part2
@DefenderCanada2 жыл бұрын
Finally made a part 2... kzbin.info/www/bejne/qJfXnIipgseKba8
@PoppinRovers2 жыл бұрын
Looking good, when is part 2?
@DefenderCanada2 жыл бұрын
Finally made a part 2... kzbin.info/www/bejne/qJfXnIipgseKba8
@heavypedalproductions3043 жыл бұрын
This is great! Any eta for part 2?
@DefenderCanada2 жыл бұрын
Finally made a part 2... kzbin.info/www/bejne/qJfXnIipgseKba8
@Terjeloe Жыл бұрын
Hi, I am planing to make a pop top defender camper. Do you have some measurements and/or drawings for the frames you made?
@DefenderCanada Жыл бұрын
Sorry, I don’t have measurements. I built it directly on another roof and made the swap after. Beams are 2x4 for the bottom and 2x1 for the top.
@Terjeloe Жыл бұрын
@@DefenderCanada Right, been thinking about the same.. but trying to get away without buying a extra roof.. but will make it a lot easier though.. cad files of the roof would be perfect.
@jamiesaunders18811 ай бұрын
Hi could you tell me the length of your gas struts please?
@DefenderCanada11 ай бұрын
400 mm compressed 905 mm extended 900 Newtons for your setup with the roof rack
@jamiesaunders18811 ай бұрын
@@DefenderCanada great, thank you for the reply. This is for our series three so no roof rack just a couple of bars and surf boards
@jamiesaunders18811 ай бұрын
@@DefenderCanada sorry to pester you but have far from the hinge to the strut?
@DefenderCanada11 ай бұрын
It basically depends on how much you want to open the roof. Start around 30° Then you have to do some math or guesstimate on site. You need to have the 2 anchor points separated by the compressed length when the roof is closed and fully extended when the roof is open. I’ll try to measure tomorrow