DIY Longboard deck (In 5 min!) Skateboard press prototype

[@mountain-roots]

Awesome job, very satisfying to see boatde being made DIY! Woodpusher for life

[@cgwoodworks1861]

Glad you liked it!

[@jacksparrow6209]

Mesurements plz I wanna try

[@f1flick]

Baltic birch plywood? I’ve used the 3mm stuff.

[@skpy8249]

I like it :) going to give it a try

[@cgwoodworks1861]

Awesome alittle less rocker on the toe and heel and alittle more tail action would be perfect. Also try to use maple plywood. As thin as possible

[@thebman80]

It looks like you uses Luan plywood. Its used as a clean sub-layer for floors. Like if you have a nasty chipped up old wood floor you put the Luan plywood over it screw it down then put floor tile on top. One of the biggest problems with it is that the top layer tends to splinter a lot when you cut it out. I'm sure routing would also be a nightmare.

[@dikenelijah2655]

Very helpful

[@cgwoodworks1861]

Glad to hear that

[@greasekidmedia1556]

Bro love the result can I ask what type of wood did you use in this? Maple is unavailable in my area

[@cgwoodworks1861]

You can try mahogony at 1/8th or 1/16th thick.

[@greasekidmedia1556]

@@cgwoodworks1861 thank you! Just Subbed 👍🏼

[@mikkonazarrea9283]

Hi new subscriber here. Can I ask what is the dimension of your press? Thank you!

[@cgwoodworks1861]

Hey bro thanks for the SUB! It is 3 foot x 9.5 inches. Hope that helps

[@aciemiller3443]

👍

[@alexsurh1472]

I didn't know the rock longboarded!

[@cgwoodworks1861]

Lol

[@mrdanino87]

👳‍♂️

[@cgwoodworks1861]

Captain Dan! Thanks for stopping by!