Рет қаралды 1,172
Placing radiant floor heating yourself and install floor insulation; 10 cm (4") thick XPS insulation plates with wire mats and underfloor heating hose on top, connected to an radiant floor heating manifold without a pump.
In preparation for pouring the concrete finishing floor, floor insulation has been applied to the concrete work floor (pouring the concrete work floor: • BETONVLOER STORTEN EN ... ).
The floor insulation is 10 cm (4") thick XPS plates; Styrodur. This was a used batch of plates from a flat roof.
Radiant floor heating wire mats or nets were placed on top of the floor insulation, after foam edge strip and foil had been applied to the walls.
Then the 16x2 PE-RT 5-layer radiant floor heating hose was laid. This on the basis of a laying plan with a c.c. distance of 10 cm (4") and per radiant floor heating group approximately a length of 70 meters of hose.
There is now a total of 542 meters of radiant floor heating hose in the new shed.
00:00 Introduction
00:08 Install floor insulation
00:36 Edge strip for concrete pouring
01:08 Laying radiant floor heating nets
02:31 Laying plan for radiant floor heating
02:36 Radiant floor heating manifold
02:54 Laying the radiant floor heating hose
03:43 Connect the radiant floor heating hose to the distributor
You watched a video of Li'l Popeye. 💪
Did you like this video? Like the video. 👍
Don't want to miss a video of Li'l Popeye? Then subscribe to LilPopeye. 🔔
Question or remark? Leave a comment! 💬
On Lil Popeye's channel ( / lilpopeye ) new videos are regularly uploaded. 🆕