DIY Slappy Stick

[@darklight4815]

yeah i knew the 4 foot version was gonna be too short so i started my 8 foot version today...i mayyyyy have a tad bit too much of a reveal on my coping,it's looking pretty damn high but i may just roll with it and finish it out...i think this obstacle is totally worth building also i wish i had seen this video a few nights ago when i drew my template out on a piece of construction paper lol...but many people will thank you for it,as do i

[@t3r083]

I forgot about this video and modelled it out in Fusion 360 using screenshots from their videos. Afterwards I remembered that I had your PDF on my computer and I put them side by side to compare, they are pretty much identical!

[@michaelalvarez5269]

hey bro! do you print this and use as template for cut the sides of slappy?? i dont understand how to it. i think i should to print it on A3 paper size

[@nostrabox]

Would it be easier to skate if the tube was sunk down a bit lower? Maybe half way?

[@legendarycuber9205]

4 isnt enough, 6 is good, but 8 is ideal 😏😉

[@PyroChemdawgxxx]

Template god! Lol thank you for this

[@cannonskateshop]

Dude, thank you so much for the template! Gonna make an 8ft version this week.

[@t3r083]

please post a vid of you shredding this thing!

[@artificer0815]

Thx for the template !