DIY Table Saw Cross Cut Sled for Bosch GTS 635-216

[@tomasdrbal5479]

Moc díky za inspiraci! Obecně doporučuji namazat styčnou plochu voskem, jezdí to pak ještě lépe

[@fannyfilms3908]

Zdravím, prima nápad děkuji..

[@Человек-к5ф]

молодец! просто молодец!

[@jaroslavpasler4832]

Mate odomňa like. Držím palce

[@vincenzosmorto3096]

i would not glue the anterior fence but only screwed it so i could adjust it if not strictly perpendicular to the blade and i had to make some fine corrections. i would also add a protection wood block for hands on the near fence along the blade cut

[@bp-synapse]

First I set it to be precise, marked and then glued and screwed. In the cutting area, it is intentionally higher so that the fingers can never come into contact with the blade

[@pasqualinatedesco8793]

@@bp-synapse Did you made a five cut test? Prudence Is never enough.

[@billgc7568]

@@pasqualinatedesco8793 I fully agree with you. I would be interested in that too. The five cut test is best for accurate results.

[@itsikalfon]

Nice, I also liked your Sara tattoo :)

[@janhvizdos]

Aký rozmer pohyblivého stola ste zvolil?

[@bp-synapse]

Myslim, ze celu tabulu jak ju predavaju v hornbachu, cca 1200*600

[@georg960]

@@bp-synapse Prosím, z jakého dřeva to je? Překližka o jaké síle? Děkuji.

[@bp-synapse]

@@georg960 ja som pouzil co dilna dala, teda preklizka 8mm. Ale ak by si chcel predvetat sachovnicu pre pouzitie svoriek je zas lepsie to urobit aspon z 15mm hrubeho materialu. banggood.onelink.me/zMT7/m5d27upe