DJI Mavic Mini stuck in reboot - Fixed

[@tyleriscool22]

Thank you so much! My drone has been in a drawer for two years with a broken gimbal. I just plastic welded it back together and ran into this issue. This video was a lifesaver

[@nometalgearr]

Hah you welcome

[@rickbpdx]

I replaced my camera/gimbal and main board. Put it all together and had the same problem as you. After watching your video, I opened up the drone and had a look. Same cable as yours was disconnected, but at the core board side. Your video took me right to the problem. Thanks for posting it. Wasn't sure where to go until I saw what you posted.

[@nometalgearr]

You're welcome. Glad it was helpful

[@johanpaulraj5146]

I had the exact same issue after replacing the 3 in 1 ribbon cable, Thank you for your help Ali...!

[@TheFishTankGuy]

I know it's been 2yrs but dude, THANK YOU! Mine was doing the same thing, I opened it and couldn't see what was wrong. Sure enough, cable was disconnected.

[@nometalgearr]

Haha you're welcome

[@fatman9141]

You are the GOAT! I use my drone everyday for work and you saved my career bro!

[@nometalgearr]

Happy it helped!

[@siriusleigh24]

A hair line crack lol, looks more like a fissure bro 😉 thanks for the vid!

[@Snaaky005]

This was a big help. I had the same problem. The connector that was causing my problem was under the heat sink on the bottom of the drone.

[@thanhtranquoc4512]

So what is your fault?

[@omrisalman9082]

I had the exact issue. Your video helped me fix my problem. Thanks

[@nometalgearr]

Good luck :)

[@ssppiikkeeboss]

I experienced the same mistake after colliding with the drone, I will disassemble it in days and try to fix it! Thank you for the video!

[@nometalgearr]

Good luck

[@GeoGebweiler]

Thanks a lot ! It fixed my problem. It was exactly the same.

[@nometalgearr]

You're welcome

[@codybrucewilliams]

if you are reading this, save yourself some time and skip to @15:30

[@nometalgearr]

Haha

[@DeffaUtama]

Thank you very much this video is a big help. My Mavic Mini suddenly went crazy mid-flight going backwards fast and hitting a wall. After that same case stuck in reboot. Opened the drone and found the connector was a bit loose and the cover protecting the chip below the Gyroscope was also loose, so I just reattached and tightened them up.

[@nometalgearr]

Nice

[@mrhood3977]

Thank you and I'm glad you were able to get it going again but mine is saying that my Mavic pro is obsolete and I can't even get an update for my drone so I guess that was a waste of $$$$

[@nometalgearr]

Ya idk

[@rodneykahane4994]

i had a similar issues, make sure all those ribbon connection cables are fitted in place flush. thanks for the video!

[@nometalgearr]

You're welcome

[@glebgrin20]

Thank you very much.

[@nometalgearr]

Nice

[@pyryhellman9668]

i have the same problems. Do you remember what error codes it gave?

[@nometalgearr]

No idea how to pull error codes. That's the only thing I did and it was working. Good luck

[@pedrocruzpizarro2051]

Code 30045