DODGY GARAGE | Replacing the Oil Pressure Sender on a Gen 2 Pajero 6G74

Due to irregular a high pressure oil reading on the gauge of the NK Gen 2 Pajero, we concluded the issue was the oil pressure sensor. We replaced it and sorted the issue.
#4wd #4x4 #pajero #mitsubishi #mitsubishipajero #montero

[@JohnMunachen]

I’ve got an earlier 97 wide body and have 2 wires but only 1 on the sender which is the right wire ??

[@dodgy_garage_4x4]

There's usually a white and a black plug from memory... it's the black one.

[@braypedersen08]

Hi mate, when you unscrewed it, Is leaked, so you need to fit the new one fast or should be right?

[@dodgy_garage_4x4]

Hi, you'll lose a bit of oil, so have the other one ready to go. Poke it in as soon as you can. This is a good job to do whilst doing an oil change, done with the filter off, and oil dropped. I actually replaced the dodgy one with a new one today, and that's what i did.

[@braypedersen08]

@@dodgy_garage_4x4 thanks mate, but i actually did the oil change 1000km ago 🥴, so maybe I should put one bowl under and then put back in. So I shouldn’t take the filter off right? I need to replace the sender because is not working and is leaking too, so I plan to buy a new one and just fit swap it

[@dodgy_garage_4x4]

@@braypedersen08 nah, just be quick with putting the new one in.

[@braypedersen08]

@@dodgy_garage_4x4 hi mate, I just tried to change mine, I bought the fuelmiser oil pressure sender CPS27, and when I tried to fit it i couldn’t And then I start researching again and I think that one is for the NL Pajero mine is NK. You know which one should I buy? Internet is very confusing in this point, repco told me that this one should fit in my car, super cheap say another one is the correct, but the terminal that they reckon is for sure different to the one that I have so Iam not sure

[@dodgy_garage_4x4]

@brianchristianpedersen8001 if you have the 6g74 3.5 DOHC then it's a Tridon TPS005

[@Ivan_kok1]

Hi sir, I have pajero 6g72 3.0 12v, my oil lamp on cluster dont work, do you know whats problem?

[@dodgy_garage_4x4]

Hi, it could be the switch/sender, or could even be the bulb in the dash cluster. It's hard to tell without looking.