Does a Nibbi Racing Vortex Throttle and Throttle Cable Make a Difference? (Install Video)

[@Sanesaint1]

First time i seen the storm i think im getting the colbolt same nice seat most of them have lousy seats colbolt the back fender points up more that broke in 8 months

[@MartinRacingChannel]

I upgraded the seat to a guts racing tall seat foam and gripper seat cover.

[@modernmountaineer]

The yellow cable would have looked sick

[@MartinRacingChannel]

@modernmountaineer I agree the bike looks pretty awesome now with the new graphics and I have a red throttle cable on it now.😁

[@sewerynsowik797]

Hello, I have an apollo rfz 125 jaguar and thinking about the nibbi 22mm. Will it be good? Mine actual carburetor cause my pit bike to bog on high rpms also feels like it’s soo weak tbh, will the nibbi help somehow? And should I change the jets or leave it as it is and try to tune it?

[@MartinRacingChannel]

kzbin.info/www/bejne/nZW0o2amp9JsepI kzbin.info/www/bejne/b3PLXoqvfLJ2j8k Check out the two links above. The nibbi carb woke mine up tremendously, the speed test video will show the proof. The 22mm should be perfect for your bike. If your bike is running perfect and tuned perfect now, you might not see a huge gain mine was significant though. After you watch the videos let me know what you think and if you have any other questions.

[@sewerynsowik797]

@@MartinRacingChannelthe speed test proces that it definitely does something, also my bike is weak (does not want to rev up while going uphill) and my actual carb is just a pain in You know where to tune because the screw is under (?) the carb and you are getting your fingers burn from cylinder while trying to do something with it + when I am doing top speed run on 4th gear my bike on high rpm just bogs and I have to let the throthle off and then on again to go on. The top speed is 40/45 km/h (not sure how much in mph it is) also can’t ride while not wide open, because it bogs in middle of the throtle so. Annoying as hell being honest hope this nibbi will help me out somehow it looks like it’s easier to tune than mine actual one. I don’t think I have any questions everything is in Your videos, also thanks for fast response! (I’m from Poland so if there are any grammar problems, Please ignore still learning)

[@MartinRacingChannel]

@sewerynsowik797 No problem at all. I hope it helps you out. You could also get a new spark plug when you install the carburetor. That way you will know the fuel and spark are good to go. Let me know how it goes after installing them. If you need any help let me know. That's Awesome we are so far apart ,thanks for checking out the channel!

[@sewerynsowik797]

@@MartinRacingChannel So I'm holding with buying new carburetor because the nibbi one is not available in any shops in my country (must order from amazon so shipping price etc.) but I have an issue with my actual one: The idle screw is doing nothing, my pit bike is goes out this screw is doing really nothing, don't know what could be wrong tbh, also I will try to get the air-to-fuel screw (This one "under" the carb) to go all the way in then 1 and 3/4 out maybe this will help somehow. Also the idle screw issue seems strange to me (Maybe some leak and getting air from where it shouldn't)

[@MartinRacingChannel]

@sewerynsowik797 kzbin.info/www/bejne/jGHJlWOYe6Zkr6M Check out this guy's videos he normally works on apollo 125s however some of the videos are a couple of years old so I'm not sure if he will respond or not. Let me know how it goes.

[@jeremyingram4097]

So I put that throttle on today and when I wick the throttle at idle from idle to wide open it bogs. I have the 22mm Nibbi on the 110cc which they recommended. I'm thinking it's a lean bog if I remember correctly the needle was in slot 3 would ya recommend going to like 4 or 5 or changing the jets? If so what jet should I change pilot or main? Thanks for the help

[@MartinRacingChannel]

Were you able to have no bog with the stock throttle tube? Or did you change everything at the same time?

[@jeremyingram4097]

@MartinRacingChannel no it's always had some bog but I think cause the new throttle moves the slide so fast it's more noticeable now. Is it true that turning the fuel screw IN richens the tune? I assume letting the screw out allows more air then? I haven't touched the jets or needle which is set on #4 slot. Was gonna try this morning turning the screw almost all the way in and raising idle and see what it does. Just what throws me off about the tuning is people say if you're out more than 2 turns on screw add a bigger jet but that kinda contradicts Nibbi s instruction of turning screw in richens the mix. I just want to rip the throttle and do wheelies with no bog lol

[@MartinRacingChannel]

@jeremyingram4097 I understand that 😏 I'm going to let you check out my install and tuning video fast forward to the end to see how it tuned mine. See if it gets you in the ballpark. I wouldn't worry too much about the amount of screw turns out as much as can you get it running right the way it is and the spark plug to look correct when running the bike hard. If you can't then start on the jets. Check my tuning video out , try the steps I used and if that doesn't work let me know and then we will start looking into other jets if you need to. kzbin.info/www/bejne/nZW0o2amp9JsepI

[@jeremyingram4097]

@@MartinRacingChannel yeah I watched this last night that's why I saw that even with the screw in you just idled up and it still ran so that's why I'm going to try that here shortly

[@MartinRacingChannel]

@@jeremyingram4097 Let me know how it does.

[@DirtyDiezel]

I love my Storm 150 DLX its a gr8 bike! I may do this upgrade, my bike is bright green soooooo it would match nicely

[@MartinRacingChannel]

It definitely catches your eyes. Super bright! That's Awesome! Glad it's a good one.

[@mikesmotoshop]

What pilot jet and settings on that carb? Needle and main?

[@MartinRacingChannel]

kzbin.info/www/bejne/nZW0o2amp9JsepI Here's a video on the installation and tuning. I run the factory jetting on the 4th needle clip.

[@Hola45213]

What’s the length of the throttle cable ?

[@michaelwachsmuth1583]

I tried putting my nibbi carb on. The cable was like 1 1/2 inches too long. Because i couldn't use the stock 90° elbow on carb cap. Did you have the same issue?

[@MartinRacingChannel]

kzbin.info/www/bejne/nZW0o2amp9JsepIsi=tlqMhEnoMwjFxvbL Check out this video at 4:38 mins and 6:05 mins and see if this helps you out. Let me know either way.

[@sheluvsjaiix2238]

Ohh wow ❤️

[@graham12v8]

What clutch lever fits the best on these bikes? Do MVS for good?

[@MartinRacingChannel]

I kept mine stock so far. My brother upgraded his to the shorter levers from pitpro racing. The stock levers are a foldable design so I haven't needed to change yet.

[@phoenixmojado527]

Nice did the cable last long ?

[@MartinRacingChannel]

Still going strong! I actually swapped to a red cable right after this video to match my new graphics. No issues though.

[@phoenixmojado527]

@@MartinRacingChannel thanks just ordered one hopefully I got the right free play inner core lol

[@MartinRacingChannel]

@phoenixmojado527 If you ordered the one from my link, it should work great. Let me know once you get it swapped out.

[@phoenixmojado527]

@@MartinRacingChannel so it the inner core was to long but this bad as cable is real adjustable that it was able to fit and function properly 🔥thanks

[@MartinRacingChannel]

Without being there I can't be much help on the stock carb , because I'm not sure about the carburetor you have. I will tell you that my bike ran perfect from the factory and my brother's did not. We had to put a new carburetor on his bike for it to run right. Now, what I would do is take the carburetor off and make sure that the main jet and the pilot jet are clean. Once you know they are perfectly clean, then you'll know if you need to look elsewhere. Make sure your air filter is tight on the carburetor, too. That way, you know there isn't extra air coming in throwing the mixture off.

[@Shane.Snowhill]

Just ordered this exact bike, super excited, the site says it goes 55, does it really go that fast?

[@MartinRacingChannel]

That's Awesome! I haven't done a top speed run with a GPS to check the speed , but I would say yes. Over or under by a few mph depending on your weight. They're quick for a pitbike! You'll be impressed if you've ever ridden a crf110 or something similar.

[@Shane.Snowhill]

@@MartinRacingChannel i ordered it off powersportsmax, it said refurbished fully assembled, the pictures it still looked brand new wrapped in plastic, hopefully it’s good when it comes

[@MartinRacingChannel]

@Shane.Snowhill cool, you probably got it for a good price too.

[@Shane.Snowhill]

@@MartinRacingChannel Yeah i got it for like $450 it’s also on sale for labor day right now but the $300 shipping is what sucks lol, also is the graphics just stickers? if i take them off i think just black and white would look really good

[@MartinRacingChannel]

@Shane.Snowhill Yeah, the shipping is tough. I wish they would let you pick them up, but it is very quick. The graphics are just stickers. The ktm 50sx graphics fit really close. You can take the stock graphics and use them to trim the others to make it fit perfectly.

[@Sanesaint1]

Factory sucks as soon as the cable comes out of the throttle it's a corner i had a Yamaha 80 that wore out there should b straight up to a bend if you ask me.