DoFeed - The ultimate high-feed cutter with maximum versatility

[@sliceum]

Hi. Thanks for sharing this impressive technique for not very rigid machines. This and some of your other videos allowed me to introduce our Hass SK40 7500 rpm machines to rough milling with unmatched cost-effective productivity in comparison to hsm milling using carbide end mills in mild steels and some tougher materials. Small investment in air solenoid and Noga CA3000 on a magnetic base to remove chips cut our machining times dramatically. I always admire your attention to detail and willingness to share knowledge in your videos.

[@TungaloyCorporation]

Thank you so much for your compliments! It means a lot to us to hear you say that! If you need support please contact us!

[@173roberto]

The last tool holder looked to me hydraulic. Is that right?

[@munirajrajesh4518]

SS, 304 material which insert's available

[@noeljochum]

Why would you use such a long Tool holder for high feed milling?

[@Mostly_simple]

kzbin.info/www/bejne/fpfWaqKZesuFgac. Have a look on this 4:30min part. Everywhere we maynot need long reach. But Highfeed tool suits

[@kuei1215]

For some of our jobs it is required.

[@JekaMandra]

leg have low live on 4 edge tool

[@metinevrensel]

can you share with us part files ? for cam

[@TungaloyCorporation]

Thank you for liking it! This does not use CAM!

[@griseldaolvera8408]

No sirbe el de 4 inserts cortador el de 2 si