STANLEY D-1610 Door Closer Parallel Arm Installation

[@toddavis8603]

Great pre-load explaination.Overall A+

[@tonymanero5544]

Curious why not install on standard position from “behind” the door with the arm on the door frame that is facing the camera.

[@nikhilmandhare3080]

Thanks for Sharing this Information.. Nice Work Keep it Up.

[@albertmichaelson6779]

Just curious why you didn't put the door closure or the old one was on the door frame? Tap the existing holes. That way you don't have for big holes in the door frame.

[@AMIR-nm7fo]

why didn't you show how to take the measurements for installation ? inches from the door frame etc.

[@CC-ls8uf]

Most closers will come with templates

[@alamgeer2005]

no mention of the template

[@jamesgonzalez3296]

So I installed an arm and the screw that connects the “joints” of the arm keeps scraping the top “lip” of the door frame. Does anyone know how to fix this without cutting a hole through the lip?

[@kellyslingerland6611]

I suspect you measured down from the frame rather than the stop, or "lip" you mention. That positions the whole closer too high on the door, causing the screw to scrape

[@brijmohanthakur7521]

That's arm shouldn't be touching door

[@albertmichaelson6779]

And he should have put it on the door frame to hide the existing holes. Guys like us have to comment of course.

[@hotrodnashes4342]

That whole video is trash needs to be taken down.

[@shaneraines2094]

Arm installation thats about it no refrence to how and why or dimensions next video how to use a paint brush! shocking