Double E E590-003 with conversions!!!

[@jgminiaturas8319]

Brasil 🚛👍

[@TinylandsRC]

great job🤩looks awesome

[@3d-masterrc861]

Thank you very much!! 🙏😊

[@nikivergi5073]

Nice job . Give as more info if you can.

[@3d-masterrc861]

Hello! Thank you very much! I stripped the entire truck chassis and added the drive axles with the wheels from the WPL B16 car. Step by step each time until the placement is done right. I put front and back extra lights which are powered by an external 18650 battery and the factory flashing ones I put all orange. The bulbs are special because they have a resistor so they don't burn at this 4.2V voltage. There are bulbs on the market that can withstand up to 12V. You can use these. I moved the carriage limit switch as you can see and forced the carriage up as I wanted to put the carriage lift mechanism on its side. It takes care and step by step to place the mechanism correctly. You have to remove with a Dremel from the factory chassis parts. I wish you good luck!

[@xdllonyou9324]

Can i put those wheels and tires withouth those other upgardes?

[@3d-masterrc861]

Hello! The rear wheels are hex studs so you can fit those tires and rims. On the steering wheel you may need to do something to get it to snap into place.