drawing a plot plan in degrees and minutes - autocad lines in degrees and minutes

[@brianjamont789]

Guys...when he says hold down the shift key and hit the angle key he meant the less than ("

[@bryankrueger308]

I cant thank you enough for saying this

[@nacangelllido4352]

Thanks!

[@lukewilson__27]

dude I've been trying to figure that out for hours!!! LOL

[@SalvadorDaliLama]

Thank you!!!

[@bronwynbrown9191]

Thanks so much!!!

[@mgarcia9352]

Thank you for showing us this video. I've spent a lot of time on KZbin for exactly what you teach us here and I couldn't find what I needed from anyone else until now. Thanks again! :)

[@hassanokidi8303]

Very nice for biginners and helpful especially for the first stage of any design

[@mariangorden97]

Super! short, sweet and to the point. Thank you

[@Slunk1337]

Thanks dude your a life saver with this tutorial. Amazing what you forget from school, hahahah cheers!

[@draftingtutorials1687]

Your welcome man! I knew I would forget this one if I didn't shoot a video on it so I'm glad it helped you out there.

[@Omar-df7hw]

Thanks man you are amazing. Keep it up

[@marteagabotero]

If you have problems with writing the angle remember minutes you have to do it with the key for question mark ? and seconds with the number 2 key mayble it change in each keyboard but maybe helps someone with the same problem that i was having.

[@thisisbasedonatruestory]

How do you show of the values after it is drawn? Basically asking how I can show [ S27D4'W ] for example

[@shenglong7]

exactly what I just need. Thanks

[@octaviosanchez4540]

Exactly what I needed. Thank you...

[@ARJ_DID]

Thank you .. For the "list " command

[@peterpauldonoghue7024]

Or if you don't want to have to Type North and East all the time .. Set UNITS to ( type) Deg/Min/Sec --- (Precision) to 0d00'00" Tick the Clockwise Box Hit the 'direction' Button and SET the 'Base Angle' to 'North' That's the way I do it, anyway OBTY ,, ' = apostrophe “ = quotation mark

[@KuyaMarkRCE]

I have a problem. I am trying to plot S. 80degree 33' E. I did what you said but it looks like N 9degree 27'W. Is that fine or that is wrong?

[@ThomasReynolds]

This is great - how do you do radius?

[@terrilarios1048]

what is the angle key you talk about? You say hit the shift and then the angle key?

[@mujtabakhan7923]

Less than symbol

[@TAIMOORALI-bm9is]

thank u man....

[@Itsjusttim365]

It would be great if we could see the what your typing on the screen.

[@jbronnier]

What is the degree key?

[@Engelke280]

Id like to know too..

[@blind3pot266]

[@BernardBlankson-op8vl]

d

[@pvy70n68]

how to read a site plan lot and area????

[@glenkaizer]

nice

[@pijusmandal7542]

ভুমি নক্সা ইডিট করা কোন অপ আছে কি থাকলে বলবেন ৷